Overview: HIP1012A
Dual Power Distribution Controller NOc1NTo-8nOR8taE8Rc-CEItNOCoTMOuErMMRTMESeNIcELhDNonEDriDcEwaDFlwOSRwRuE.ipPnNpLtEeoArWrsCt iCElD.ceMEonSEmtIeNG/rTtNsacSt DATASHEET
FN4419 Rev 6.00 March 2004 The HIP1012A is a HOT SWAP dual supply power distribution controller. Two external N-Channel MOSFETs are driven to distribute power while providing load fault isolation.
At turn-on, the gate of each external N-Channel MOSFET is charged with a 10A current source. Capacitors on each gate (see the Typical Application Diagram), create a programmable ramp (soft turn-on) to control inrush currents. A built in charge pump supplies the gate drive for the 12V supply N-Channel MOSFET switch.
Overcurrent protection is facilitated by two external current sense resistors. When the current through either resistor exceeds the user programmed value the controller enters the current regulation mode. The time-out capacitor, CTIM, starts charging as the controller enters the time out period. Once CTIM charges to a 2V threshold, the N-Channel MOSFETs are latched off. In the event of a fault at least three times the current limit level, the N-Channel MOSFET gates are pulled low immediately before entering time out period. The controller is reset by a rising edge on either PWRON pin.
Choosing the voltage selection mode the HIP1012 controls either +12V/5V or +3.3V/+5V supplies. Ordering Information PART NUMBER TEMP. RANGE (°C) PACKAGE PKG. DWG. # HIP1012ACB -0 to 70 14 Ld SOIC M14.15 HIP1012ACBZA (Note) -0 to 70 14 Ld SOIC( Pb-free) M14.15 NOTE: Intersil Pb-free products employ special Pb-free material sets; molding pounds/die attach materials and 100% matte tin plate termination finish, which is patible with both SnPb and Pb-free soldering operations. Intersil Pb-free products are MSL classified at Pb-free peak reflow temperatures that meet or exceed the Pb-free requirements of IPC/JEDEC J Std-020B.
