SGM40642 Datasheet | SG Micro

DESCRIPTION FEATURES The SGM40642 is a smart low voltage load switch with a full suite of protective features that can protect the source, device, and the load against a variety of fault conditions. This e Fuse device is suitable for 2.5V to 5V loads and provides accurate and adjustable current limiting (700m A to 2.9A) and over-voltage clamping (5.4V TYP). It can deliver 2.5A continuous current to the load and its input tolerates up to 20V over-voltage. In over-voltage conditions, the internal switch is turned off to keep the load disconnected with the SGM40642. If the source voltage is higher than 5.4V but lower than 7.6V, the output will be clamped to 5.4V to protect the load. If the VIN voltage exceeds 7.6V, the load will be disconnected to prevent damage. The SGM40642 has an internal 54mΩ (TYP) power switch with current limit capability. This limit is programmable with a single external resistor (RILIM). A persistent overload condition usually results in thermal shutdown and may cause cyclic ON and OFF periods to protect the device. The SGM40642 is available in a Green TDFN-2×2-6AL package and can operate over the -40℃ to +125℃ ambient temperature range. - 2.5V to 6.5V Operation - 54mΩ (TYP) Internal Switch (High-side MOSFET) - Up to 2.5A Continuous Load Current - Up to 20V Input Over-Voltage Tolerance - Output Shutoff at 7.6V (TYP) Input Over-Voltage - 100ns Over-Voltage Lockout (OVLO) Response - 3.5μs Short-Circuit Response - Reverse Current Blocking while Disabled - Built-In Soft-Start - Pin-to-Pin patible with SGM2553 - -40℃ to +125℃ Operating Temperature Range - Available in a Green TDFN-2×2-6AL Package APPLICATIONS USB Power Switches USB Slave Devices Smart Phones/Cell Phones 3G, 4G Wireless Data-Cards Solid State Drives (SSD) 3V or 5V Adapter Powered Devices TYPICAL APPLICATION IN VIN 1μF 330kΩ n FAULT RPG 300kΩ Fault Signal EN SGM40642 OUT VOUT ILIM COUT 1μF RILIM NOTE: To select the RILIM value, use either the Electrical...