SPMB250-A1 Datasheet | STMicroelectronics

.. MOTIONBEE™ family acceleration sensor Preliminary Data Features - - - - - Ready-to-use IEEE 802.15.4 pliant wireless acceleration sensor Integrated three axis MEMS-based linear accelerometer Antenna on board No external ponents required excluding power supplier Possibility to be programmed via SIF connector with EMZNET Zig Bee® protocol stack and custom applications Board fixing with screws or pads for SMD soldering Reset and missioning push buttons externally available Power connector and power switch externally available Two LEDs externally available for connection check and debugging Board dimensions: 49 x 27 x 5 mm CE / FCC pliant - - - - - - The Zig Bee® module contains the SN250 So C integrating a fully pliant 802.15.4 radio together with a microcontroller that can be used to elaborate sensor data and networking functionalities. SN250 can be programmed to run the EMZNET Zig Bee® protocol stack from Ember Corporation. The module is programmable thanks to the SIF connector available on the SPZB250 module. The LIS3LV02DL three axis accelerometer is a low power low voltage linear accelerometer with digital output that can operate in the user selectable range +/-2 g or +/-6 g and with programmable data rate. The controller inside SPZB250 module handles all the networking functions and it can be used to implement custom procedures to elaborate and send data collected by the acceleration sensor. The board is ready-to-use, requiring only an external power supplier to connect to the integrated standard two pole connector. A switch is present in series to the supply connection to power on / off the board. Description SPMB250-A1 board is a ready-to-use wireless acceleration sensor based on an IEEE 802.15.4 pliant radio. It is designed to enable development of applications for remote motion monitoring in wireless sensor networks systems. The board is based on the Zig Bee® module SPZB250 which performs both the RF radio...