Datasheet4U Logo Datasheet4U.com

AAT4650 - 5V/3V PC Card Power Switch

General Description

The AAT4650 SmartSwitch is a single channel PC card (PCMCIA) power switch.

It is used to select between two different voltage inputs, each between 2.7V and 5.5V.

An internal switch powers the circuitry from whichever input voltage is higher.

Key Features

  • 2.7V to 5.5V Input Voltage Range.
  • 80m (5V) Typical RDS(ON).
  • Low Quiescent Current 15μA (typ).
  • Reverse-Blocking Switches.
  • Short-Circuit Protection.
  • Over-Temperature Protection.
  • FAULT Flag Output.
  • Temperature Range: -40°C to +85°C.
  • 8-Pin SOP Package.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
AAT4650 5V/3V PC Card Power Switch Advanced Analogic Technologies
AAT4651 5V/3V PC Card Power Switch Advanced Analogic Technologies
AAT4601 1.5A Current Limited P-Channel Switch Advanced Analogic Technologies
AAT4601 1.8A Current Limited P-Channel Switch Skyworks
AAT4601A 1.8A Current Limited P-Channel Switch Advanced Analogic Technologies

Other Datasheets by Skyworks Solutions

Part Number Description
AAT4611 Current Limited Load Switch
AAT4618 Current Limited Load Switch
AAT4625 USB Single-Channel Power Switch
AAT4626 USB Dual-Channel Power Switch
AAT4644 4-Channel Current Limited Load Switch

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
General Description The AAT4650 SmartSwitch is a single channel PC card (PCMCIA) power switch. It is used to select between two different voltage inputs, each between 2.7V and 5.5V. An internal switch powers the circuitry from whichever input voltage is higher. The device’s output, VCC, is slew rate controlled and current limited, in compliance with PC card specifications. The current limit response time to a short circuit is typically 1μs. The internal P-channel MOSFET switches are configured to break before make; that is, both switches cannot be closed at the same time. Controlled by a 2-bit parallel interface, the four states for VCC are VCC5, VCC3, high impedance, or ground. When in the ground state, VCC is pulled to ground by a 5k resistor.