MAAVCC0001 Datasheet | Tyco Electronics

Voltage Variable Absorptive Attenuator 800 - 1000 MHz V 2.00 Features n n n n n n n n n n CSP-8, 28 Lead, 6mm Input IP3: +31 d Bm Min. (Full Attenuation Range) Input IP3 is 15 -20 d B Better Than Ga As Linear Operation: +20 d Bm Min. Plastic, 28 Lead, 6 mm CSP, SMT Package 38 d B Dynamic Range (With 30 m A Bias Current) Single Control Voltage 50 ohm Impedance Linear Driver, DR65-0002, Available Test Boards are Available Tape and Reel Packaging Available Description M/A-'s MAAVCC0001 is a PIN diode based voltage variable attenuator. This device is in a 6mm square, 28 lead, plastic CSP Package, suitable for surface mounting on PCBs. These attenuators have linear operating power and input intercept point levels 15 - 20 d B better than Ga As FET MMIC voltage variable attenuators. They are ideally suited for use where low distortion, high linear operating power and high dynamic range are required. These devices are optimized for the GSM frequency band, but exhibit excellent performance and repeatability over the entire specified frequency band. The MAAVCC0001 is ideally suited for wireless munications systems. Package outline conforms to JEDEC standard MO-220B. Electrical Specifications: TA = 25°C Parameter Insertion Loss Attenuation (Above Loss) Frequency Flatness VSWR Switching Speed Linear Operation Input IP3 I Control Test Conditions 0 volts 12 m A bias current 0 to 30 d B attenuation 0 to 30 d B attenuation 50% Control to 90%/10% RF - Two-tone inputs up to +10 d Bm - Frequency 800-1000 MHz 925 - 960 MHz 800-1000 MHz 925 - 960 MHz 800-1000 MHz 925 - 960 MHz 800-1000 MHz 925 - 960 MHz 800-1000 MHz 800-1000 MHz 800-1000 MHz 800-1000 MHz Units d B d B d B d B d B d B Ratio Ratio µS d Bm d Bm m A Min. - - 30 30 - - - - - - +35 - Typ. 3.6 3.5 34 34 2.3 0.4 1.5:1 1.3:1 - +20 +40 - Max. 4.2 3.9 - - 3.0 0.8 1.9:1 1.8:1 10.0 - - 30 Voltage Variable Absorptive Attenuator 800 - 1000 MHz V...