DS3658 Datasheet | Texas Instruments

FEATURES - 2 Single Saturated Transistor Outputs - Low Standby Power, 10 m W Typical - High Impedance TTL patible Inputs - Outputs May Be Tied Together for Increased Current Capacity - High Output Current - 600 m A Per Output - 2.4A Per Package - No Output Latch-up at 35V - Low Output ON Voltage (350 m V typ @ 600 m A) - High Breakdown Voltage (70V) - Open Collector Outputs - Output Clamp Diodes for Inductive Fly Back Protection - NPN Inputs for Minimal Input Currents (1 µA Typical) - Low Operating Power - Standard 5V Power Supply - Power Up/Down Protection - Fail Safe Operation - 2W Power Package - Pin-for-Pin patible with SN75437 DESCRIPTION The DS3658 quad peripheral driver is designed for those applications where low operating power, high breakdown voltage, high output current and low output ON voltage are required. A unique input circuit bines TTL patibility with high impedance. In fact, its extreme low input current allows it to be driven directly by a CMOS device. The outputs are capable of sinking 600 m A each and offer a 70V breakdown. However, for inductive loads the output should be clamped to 35V or less to avoid latch-up during turn off (inductive fly back protection- refer to AN-213 'SNOA610'). An on-chip clamp diode capable of handling 800 m A is provided at each output for this purpose. In addition, the DS3658 incorporates circuitry that specifies glitchfree power up or down operation and a fail-safe feature which puts the output in a high impedance state when the input is open. The PDIP package is specifically constructed to allow increased power dissipation over conventional packages. The four ground pins are directly connected to the device chip with a special cooper lead frame. When the quad driver is soldered into a PC board, the power rating of the device improves significantly. APPLICATIONS - Relay Drivers - Lamp Drivers - Solenoid Drivers - Hammer Drivers - Stepping Motor Drivers - Triac Drivers - LED Drivers - High Current, High Voltage Drivers...