Datasheet4U Logo Datasheet4U.com

AP1041 - H-Bridge Motor Driver

General Description

The AP1041 is a 1ch H-Bridge motor driver that supports a maximum output current of 1.0A and from 8 to 32V operation voltage.

The control mode of the AP1041 can be switched between parallel input mode and complemental input mode by the SEL pin.

Key Features

  • Motor Drive Voltage : 8V~32V (Single Power Supply).
  • Control Power Supply : Not Necessary.
  • Maximum Output Current (DC) : 0.9A @Ta=25°C.
  • Maximum Output Current (Peak) : 1.0A @Ta=25°C, t.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
AP100-B10 AC Current transducer LEM
AP100-B420L AC Current transducer LEM
AP1001BSQ N-CHANNEL ENHANCEMENT MODE POWER MOSFET Advanced Power Electronics
AP1001BSQ-3 N-CHANNEL ENHANCEMENT MODE POWER MOSFET Advanced Power Electronics
AP1002BMX-3 N-CHANNEL ENHANCEMENT MODE POWER MOSFET Advanced Power Electronics

Other Datasheets by AKM (Asahi Kasei Microdevices)

Part Number Description
AP1040 H-Bridge Motor Driver
AP1042 H-Bridge Motor Driver
AP1010 H-Bridge Motor Driver
AP1014AEC Dual H-Bridge Motor Driver
AP1015BEN H-Bridge Motor Driver

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
[AP1041] AP1041 32V 1ch H-Bridge Motor Driver IC 1. General Description The AP1041 is a 1ch H-Bridge motor driver that supports a maximum output current of 1.0A and from 8 to 32V operation voltage. The control mode of the AP1041 can be switched between parallel input mode and complemental input mode by the SEL pin. The built-in PWM duty control circuit enables speed adjustment of the motor by the VREF voltage for both forward and reverse rotations. The AP1041 has a through current prevention, a low voltage detection, a thermal protection and an overcurrent protection circuits for the output stage as protection circuits. The detection time of the overcurrent protection circuit can be adjusted by the resistance value connected to the TBLANK pin.