Datasheet4U Logo Datasheet4U.com

AT79C1010 - 4-port Layer 2 Unmanaged Switched Ethernet Controller

Description

The AT79C1010 is an Ethernet switch controller that performs Layer 2 Switching according to IEEE 802 standards.

It adopts the crossbar architecture to complete the function of packets switching between 4 MII ports.

Features

  • 4 10/100M Ethernet MII Ports Meet Fast Ethernet Requirements Provides Packets Switching Function Between 4 Ethernet Ports Crossbar Switching Engine Performs Switching at Wire Speed Full/Half Duplex Mode Interface Supported Flow Control for Full-duplex Supported MAC Address Table is Integrated in the Single-chip MAC Address Aging is Supported Input/Output Buffer Memory Embedded for Each Port MDIO I.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
AT704 PHASE CONTROL THYRISTOR Power Semiconductors
AT706 PHASE CONTROL THYRISTOR Power Semiconductors
AT708 PHASE CONTROL THYRISTOR Power Semiconductors
AT7109 800mA Synchronous Step-Down Converter iAT
AT7170 1A 1.5MHz Step-Down Converter iAT

Other Datasheets by Atmel (Microchip)

Part Number Description
AT79C1020 4-port Layer 2 10/100/1000Mbps Unmanaged Switched Ethernet Controller
AT79C1030 8-Port Gigabit Ethernet CoS Switch
AT7910E SpW-10X SpaceWire Router
AT7911E Triple SpaceWire links High Speed Controller
AT7912E Single SpaceWire link High Speed Controller

Full PDF Text Transcription

Click to expand full text
www.DataSheet4U.com Features • • • • • • • • • • 4 10/100M Ethernet MII Ports Meet Fast Ethernet Requirements Provides Packets Switching Function Between 4 Ethernet Ports Crossbar Switching Engine Performs Switching at Wire Speed Full/Half Duplex Mode Interface Supported Flow Control for Full-duplex Supported MAC Address Table is Integrated in the Single-chip MAC Address Aging is Supported Input/Output Buffer Memory Embedded for Each Port MDIO Interface is Supported Available in a Variety of Packages Depending on Customer Requirements Description The AT79C1010 is an Ethernet switch controller that performs Layer 2 Switching according to IEEE 802 standards. It adopts the crossbar architecture to complete the function of packets switching between 4 MII ports.
Published: |