Download the CY7B8392 datasheet PDF.
This datasheet also covers the CY7B8392-1 variant, as both devices belong to the same low power ethernet coaxial transceiver family and are provided as variant models within a single manufacturer datasheet.
General Description
It is possible, through the use of repeaters, to combine several networks together.
These networks can be a single Physical layer, i.e., only 10BASE2 or only 10BASE5, or it can by a combination of many different Ethernet physical layers.
Key Features
signal is necessary before it can be amplified and sent to the DTE. The CY7B8392 receiver circuitry has.
Full PDF Text Transcription for CY7B8392 (Reference)
Note: Below is a high-fidelity text extraction (approx. 800 characters) for
CY7B8392. For precise diagrams, and layout, please refer to the original PDF.
CY7B8392 Low Power Ethernet Coaxial Transceiver Application This application note describes the differences between the 10BASE5 (Ethernet) and 10BASE2 (Cheapernet) versio...
View more extracted text
erences between the 10BASE5 (Ethernet) and 10BASE2 (Cheapernet) versions of the IEEE 802.3 standard, and provides guidelines for design with the CY7B8392. Data is sent out over the network in packets. An Ethernet packet consists of the preamble, destination address, source address, length field, data, and a Cyclic Redundancy Check (CRC). Each packet can be viewed as a sequence of 8-bit bytes, with the least significant bit of each byte being transmitted first. A typical Ethernet packet is shown in Figure 3. The preamble contains 8 bytes of alternating ones and zeros, ending with two consecutive ones. The preamble allows th
CY7B8392 Datasheet
