IR2130 Datasheet | International Rectifier

Data Sheet No. PD60019 Rev.P IR2130/IR2132(J)(S) & (Pb F) 3-PHASE BRIDGE DRIVER Features - Floating channel designed for bootstrap operation - - - - - - - - - Fully operational to +600V Tolerant to negative transient voltage d V/dt immune Gate drive supply range from 10 to 20V Undervoltage lockout for all channels Over-current shutdown turns off all six drivers Independent half-bridge drivers Matched propagation delay for all channels 2.5V logic patible Outputs out of phase with inputs Cross-conduction prevention logic Also available LEAD-FREE Product Summary VOFFSET IO+/VOUT ton/off (typ.) Deadtime (typ.) 600V max. 200 m A / 420 m A 10 - 20V 675 & 425 ns 2.5 µs (IR2130) 0.8 µs (IR2132) Description Packages The IR2130/IR2132(J)(S) is a high voltage, high speed power MOSFET and IGBT driver with three independent high and low side referenced output channels. Proprietary HVIC technology enables ruggedized 28-Lead SOIC monolithic construction. Logic inputs are patible with CMOS or LSTTL outputs, down to 2.5V logic. A 28-Lead PDIP ground-referenced operational amplifier provides analog feedback of bridge current via an external current sense resistor. A current trip function which termi44-Lead PLCC w/o 12 Leads nates all six outputs is also derived from this resistor. An open drain FAULT signal indicates if an over-current or undervoltage shutdown has occurred. The output drivers feature a high pulse current buffer stage designed for minimum driver cross-conduction. Propagation delays are matched to simplify use at high frequencies. The floating channels can be used to drive N-channel power MOSFETs or IGBTs in the high side configuration which operate up to 600 volts. Typical Connection (Refer to Lead Assignments for correct pin configuration). This/These diagram(s) show electrical connections only. Please refer to our Application Notes and Design Tips for proper circuit board layout. .irf. IR2130/IR2132(J)(S) & (Pb...