Datasheet4U Logo Datasheet4U.com

MP6513L - H-Bridge Motor Driver

General Description

The MP6513L is an H-bridge motor driver used for driving reversible motors, which can drive one DC motor, one winding of a stepper motor, or other loads.

The H-bridge consists of four Nchannel power MOSFETs.

An internal charge pump generates the necessary gate-drive voltages.

Key Features

  • include over-current protection (OCP), short-circuit protection (SCP), under-voltage lockout (UVLO), and overtemperature protection (OTP). The MP6513L requires a minimum number of readily available, standard, external components and is available in a TSOT23-6 package.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
MP6501A Power Transistor Toshiba Semiconductor
MP6 AC-DC / Configurable Emerson
MP60-E PENTIUM PRO PROCESSOR VOLTAGE REGULATOR MODULE Semtech Corporation
MP60-F KLAMATH PROCESSOR VOLTAGE REGULATOR MODULE Semtech Corporation
MP6005 SINGLE-PHASE SILICON BRIDGE RECTIFIER Dc Components

Other Datasheets by Monolithic Power Systems

Part Number Description
MP6513LGJ H-Bridge Motor Driver
MP6513 H-Bridge Motor Driver
MP6513GJ H-Bridge Motor Driver
MP6510 Single-Phase Brushless DC Motor Driver
MP6514 H-Bridge Motor Driver

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
MP6513L 2.5V - 5.5V, 0.6A, H-Bridge Motor Driver in a TSOT23-6 DESCRIPTION The MP6513L is an H-bridge motor driver used for driving reversible motors, which can drive one DC motor, one winding of a stepper motor, or other loads. The H-bridge consists of four Nchannel power MOSFETs. An internal charge pump generates the necessary gate-drive voltages. The MP6513L operates on a motor power supply voltage from 2.5V to 5.5V, which can supply an output current of up to 0.6A according to the logic control. The MP6513L is controlled by two input pins. The two on/off inputs determine the output mode: forward, reverse, coast, or brake. Brake is applied when stopping the motor (when inputs 1 and 2 are both at a high level).