Datasheet4U Logo Datasheet4U.com

LX5205 - 18-LINE PLUG AND PLAY/ POWER SCSI TERMINATOR

Description

The LX5205 is an eighteen line active terminator for the SCSI parallel bus.

This SCSI standard recommends active termination at both ends of the SCSI bus.

During disconnect mode, the LX5205 requires a meager 500nA of supply current while offering only 2.5pF of output capacitance.

📥 Download Datasheet

Datasheet preview – LX5205

📁 Similar Datasheet

  • LX527 - CMOS (ZHENGXIN)
  • LX5115 - ULTRA 9-CHANNEL SCSI TERMINATOR (LINFINITY)
  • LX5115A - ULTRA 9-CHANNEL SCSI TERMINATOR (LINFINITY)
  • LX550 - Flexible single and multiple outputs (Artesyn Technologies)
  • LX5510B - InGaP HBT 2.4 - 2.5 GHz Power Amplifier (Microsemi)
  • LX5511 - InGaP HBT 2.3 - 2.5 GHz Power Amplifier (Microsemi)
  • LX5516 - InGaP HBT 2.4 - 2.5 GHz Power Amplifier Module (Microsemi)
  • LX5518 - InGaP HBT 2.4 - 2.5 GHz Power Amplifier (Microsemi)
  • LX5530LQ - High Power 4.5 to 6.0GHz Wireless LAN Power Amplifier (Microsemi)
Other Datasheets by Microsemi Corporation
  • LX5202 - 18-LINE/ POWER SCSI TERMINATOR
  • LX5203 - 9-LINE SCSI ACTIVE TERMINATOR
  • LX5204 - 9-LINE HOT SWAP/ POWER SCSI TERMINATOR
  • LX5207 - 18-LINE LOW CAPACITANCE/ POWER SCSI TERMINATOR
  • LX5208 - 18-LINE LOW CAPACITANCE/ POWER SCSI TERMINATOR
  • LX5211 - 9-LINE LOW CAPACITANCE/ POWER SCSI TERMINATOR
  • LX5212 - 9-LINE LOW CAPACITANCE/ POWER SCSI TERMINATOR
  • LX5213 - 9-LINE LOW CAPACITANCE/ POWER SCSI TERMINATOR

Full PDF Text Transcription

Click to expand full text
LIN D O C #: 5205 LX5205 18-L INE P LUG T H E AND P LAY , µP OWER SCSI T ERMINATOR D A T A I N F I N I T E P O W E R O F I N N O VA T I O N P R E L I M I N A R Y S H E E T DESCRIPTION The LX5205 is an eighteen line active terminator for the SCSI parallel bus. This SCSI standard recommends active termination at both ends of the SCSI bus. During disconnect mode, the LX5205 requires a meager 500nA of supply current while offering only 2.5pF of output capacitance. To enter this low power mode, the disconnect pins can be left open (floating) or driven low thereby disconnecting the terminating resistors and placing the internal low dropout regulator into low power mode.
Published: |