Datasheet4U Logo Datasheet4U.com

MC3371 - (MC3372) LOW POWER FM IF

Description

OPERATING CONDITIONS VCC = 4.0 Vdc, RFIn = 100 µV, fmod = 1.0 kHz, fdev = 3.0 kHz.

MC3371 at fRF = 10.7 MHz (see Figure 11).

Pin 1 Symbol OSC1 Internal Equivalent Circuit Description The base of the Colpitts oscillator.

Features

  • 50 µA 6.

📥 Download Datasheet

Datasheet preview – MC3371

Datasheet Details

Part number MC3371
Manufacturer Motorola
File Size 471.92 KB
Description (MC3372) LOW POWER FM IF
Datasheet download datasheet MC3371 Datasheet
Additional preview pages of the MC3371 datasheet.

📁 Similar Datasheet

  • MC3371 - Low Power Narrowband FM IF (LANSDALE Semiconductor)
  • MC3372 - Low Power Narrowband FM IF (LANSDALE Semiconductor)
  • MC33730 - Switch Mode Power-Supply (NXP)
  • MC33761 - Ultra Low-Noise Low Dropout Voltage Regulator (ON Semiconductor)
  • MC33762 - Dual Ultra Low-Noise Low Dropout Voltage Regulator (ON Semiconductor)
  • MC33765 - Very Low Dropout/Ultra Low Noise 5 Outputs Voltage Regulator (ON Semiconductor)
  • MC33771BSA1AE - Battery cell controller (NXP)
  • MC33771BSA2AE - Battery cell controller (NXP)
  • MC33771BSB1AE - Battery cell controller (NXP)
  • MC33771BSB2AE - Battery cell controller (NXP)
Other Datasheets by Motorola
  • MC33702 - Microprocessor Power Supply
  • MC3370P - Zero Voltage Switch
  • MC3372 - Low Power Narrowband FM IF
  • MC3373 - Remote Control Amplifier/Detector
  • MC3374 - LOW VOLTAGE SINGLE CONVERSION FM RECEIVER
  • MC33742 - System Basis Chip (SBC) with Enhanced High-Speed CAN Transceiver
  • MC33790 - Two-Channel Distributed System Interface (DSI) Physical Interface Device
  • MC33793 - Distributed System Interface (DSI) Sensor Interface

Full PDF Text Transcription

Click to expand full text
Order this document by MC3371/D Low Power Narrowband FM IF The MC3371 and MC3372 perform single conversion FM reception and consist of an oscillator, mixer, limiting IF amplifier, quadrature discriminator, active filter, squelch switch, and meter drive circuitry. These devices are designed for use in FM dual conversion communication equipment. The MC3371/MC3372 are similar to the MC3361/MC3357 FM IFs, except that a signal strength indicator replaces the scan function controlling driver which is in the MC3361/MC3357. The MC3371 is designed for the use of parallel LC components, while the MC3372 is designed for use with either a 455 kHz ceramic discriminator, or parallel LC components. These devices also require fewer external parts than earlier products.
Published: |