Datasheet4U Logo Datasheet4U.com

MC33883 - H-Bridge Gate Driver

Description

The 33883 is an H-bridge gate driver (also known as a full-bridge pre-driver) IC with integrated charge pump and independent high and low side gate driver channels.

Features

  • VCC operating voltage range from 5.5 V up to 55 V.
  • VCC2 operating voltage range from 5.5 V up to 28 V.
  • CMOS / LSTTL compatible I / O.
  • 1.0 A peak gate driver current.
  • Built-in high side charge pump.
  • Under-voltage lockout (UVLO).
  • Over-voltage lockout (OVLO).
  • Global enable with.

📥 Download Datasheet

Datasheet preview – MC33883

Datasheet Details

Part number MC33883
Manufacturer NXP
File Size 480.62 KB
Description H-Bridge Gate Driver
Datasheet download datasheet MC33883 Datasheet
Additional preview pages of the MC33883 datasheet.

📁 Similar Datasheet

  • MC33883 - H-Bridge Gate Driver (Motorola)
  • MC33880 - CONFIGURABLE OCTAL SERIAL SWITCH WITH SERIAL PERIPHERAL INTERFACE (Motorola)
  • MC33882 - Six-Output Low-Side Switch (Motorola)
  • MC33884 - SWITCH MONITOR INTERFACE (Motorola)
  • MC33886 - 5.0A H-BRIDGE (Motorola)
  • MC33887 - 5.0 A H-Bridge with Load Current Feedback (Motorola)
  • MC33888 - Quad High-Side and Octal Low-Side Switch for Automotive (Motorola)
  • MC33888A - Quad High-Side and Octal Low-Side Switch for Automotive (Motorola)
  • MC33889 - System Base Chip - Lite With Low Speed CAN (Motorola)
  • MC3380P - Emitter Coupled Astable Multivibrator (Motorola Semiconductor)
Other Datasheets by NXP
  • MC33882 - Six Output Low-side Switch
  • MC33887 - 5.0A H-Bridge with Load Current Feedback
  • MC33889 - System basis chip
  • MC33812 - Multifunctional Ignition and Injector Driver
  • MC33814 - Two cylinder small engine controller
  • MC33816 - SD6 programmable solenoid controller
  • MC33879 - Configurable octal serial switch
  • MC33897 - Single Wire CAN Transceiver

Full PDF Text Transcription

Click to expand full text
SO20 MC33883 H-Bridge Gate Driver IC Rev. 11.0 — 27 April 2020 Data sheet: technical data 1 General description The 33883 is an H-bridge gate driver (also known as a full-bridge pre-driver) IC with integrated charge pump and independent high and low side gate driver channels. The gate driver channels are independently controlled by four separate input pins, thus allowing the device to be optionally configured as two independent high side gate drivers and two independent low side gate drivers. The low side channels are referenced to ground. The high side channels are floating. The gate driver outputs can source and sink up to 1.0 A peak current pulses, permitting large gate-charge MOSFETs to be driven and/or high pulse- width modulation (PWM) frequencies to be utilized.
Published: |