Datasheet4U Logo Datasheet4U.com

NX3L2G384 - Dual low-ohmic single-pole single-throw analog switch

General Description

The NX3L2G384 provides two low-ohmic single pole single throw analog switch functions.

Each switch has two input/output terminals (nY and nZ) and an active LOW enable input (nE).

When pin nE is HIGH, the analog switch is turned off.

Key Features

  • I Wide supply voltage range from 1.4 V to 3.6 V I Very low ON resistance (peak): N 1.6 Ω (typical) at VCC = 1.4 V N 1.0 Ω (typical) at VCC = 1.65 V N 0.55 Ω (typical) at VCC = 2.3 V N 0.50 Ω (typical) at VCC = 2.7 V I High noise immunity I ESD protection: N HBM JESD22-A114E Class 3A exceeds 7500 V N MM JESD22-A115-A exceeds 200 V N CDM AEC-Q100-011 revision B exceeds 1000 V I CMOS low-power consumption I Latch-up performance exceeds 100 mA per JESD 78 Class II Level A I Direct interface with TTL.

📥 Download Datasheet

Other Datasheets by NXP Semiconductors

Part Number Description
NX3L2T66 Dual low-ohmic single-pole single-throw analog switch
NX3L1G3157 Low-ohmic single-pole double-throw analog switch
NX3L1G66 Low-voltage analog switch
NX3L1T3157 Low-ohmic single-pole double-throw analog switch
NX3L1T5157 Low-ohmic single-pole double-throw switch
NX3L4051 Single low-ohmic 8-channel analog switch
NX3008CBKS MOSFET
NX3008CBKV MOSFET
NX3008NBKMB MOSFET
NX3008NBKS 350mA dual N-channel Trench MOSFET

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
NX3L2G384 Dual low-ohmic single-pole single-throw analog switch Rev. 01 — 18 September 2008 www.datasheet4u.com Product data sheet 1. General description The NX3L2G384 provides two low-ohmic single pole single throw analog switch functions. Each switch has two input/output terminals (nY and nZ) and an active LOW enable input (nE). When pin nE is HIGH, the analog switch is turned off. Schmitt-trigger action at the enable input (nE) makes the circuit tolerant to slower input rise and fall times across the entire VCC range from 1.4 V to 3.6 V. The NX3L2G384 allows signals with amplitude up to VCC to be transmitted from nY to nZ; or from nZ to nY. Its low ON resistance (0.5 Ω) and flatness (0.13 Ω) ensures minimal attenuation and distortion of transmitted signals. 2.