900,000+ datasheet pdf search and download

Datasheet4U offers most rated semiconductors data sheet pdf






Peregrine Semiconductor

PE4239 Datasheet Preview

PE4239 Datasheet

SPDT UltraCMOS RF Switch

No Preview Available !

Product Description
The PE4239 UltraCMOS® RF switch is designed to cover a
broad range of applications from DC through 3.0 GHz. This
reflective switch integrates on-board CMOS control logic with a
low voltage CMOS-compatible control interface, and can be
controlled using either single-pin or complementary control
inputs. Using a nominal +3V power supply voltage, a typical
input 1 dB compression point of +27 dBm can be achieved.
The PE4239 UltraCMOS RF switch is manufactured on
Peregrine’s UltraCMOS process, a patented variation of silicon-
on-insulator (SOI) technology on a sapphire substrate, offering
the performance of GaAs with the economy and integration of
conventional CMOS.
Figure 1. Functional Diagram
RFC
RF1 RF2
Product Specification
PE4239
SPDT UltraCMOS® RF Switch
Features
Single-pin or complementary CMOS
logic control inputs
+3.0V power supply needed for single-
pin control mode
Low insertion loss: 0.7 dB at 1.0 GHz,
0.9 dB at 2.0 GHz
Isolation of 32 dB at 1.0 GHz, 23 dB at
2.0 GHz
Typical input 1 dB compression point of
+27 dBm
Ultra-small 6-lead SC-70 package
Figure 2. Package Type SC-70
6-lead SC-70
CMOS
Control
Driver
CTRL CTRL or VDD
Table 1. Electrical Specifications @ +25 °C, VDD = 3V (ZS = ZL = 50)
Parameter
Operation Frequency1
Conditions
Minimum
DC
Insertion Loss
Isolation
Return Loss
1000 MHz
2000 MHz
1000 MHz
2000 MHz
1000 MHz
2000 MHz
30
21
18
16
‘ON’ Switching Time
50% CTRL to 0.1 dB of final value, 1 GHz
Typical
0.7
0.9
32
23
20
18
300
Maximum
3000
0.85
1.05
Units
MHz
dB
dB
dB
dB
dB
dB
ns
‘OFF’ Switching Time
50% CTRL to 25 dB isolation, 1 GHz
200 ns
Video Feedthrough2
15 mVpp
Input 1 dB Compression
2000 MHz
26 27
dBm
Input IP3
2000 MHz, 14 dBm input power
43 45
dBm
Notes: 1. Device linearity will begin to degrade below 10 MHz.
2. The DC transient at the output of any port of the switch when the control voltage is switched from Low to High or High to Low in a 50Ω test
set-up, measured with 1ns risetime pulses and 500 MHz bandwidth.
Document No. DOC-56568-2 www.psemi.com
©2002-2016 Peregrine Semiconductor Corp. All rights reserved.
Page 1 of 9




Peregrine Semiconductor

PE4239 Datasheet Preview

PE4239 Datasheet

SPDT UltraCMOS RF Switch

No Preview Available !

Figure 3. Pin Configuration (Top View)
pin 1
RF1 1
GND 2
RF2 3
6 CTRL or VDD
5 RFC
4 CTRL
Table 2. Pin Descriptions
Pin Pin
No. Name
Description
1 RF1 RF1 port (Note 1)
Ground connection. Traces should be
2
GND
physically short and connected to
ground plane for best performance.
3 RF2 RF2 port (Note 1)
4
CTRL
Switch control input, CMOS logic level.
5
RFC
Common RF port for switch (Note 1)
This pin supports two interface options:
Single-pin control mode. A nominal 3V
supply connection is required.
6
CTRL or
VDD
Complementary-pin control mode. A
complementary CMOS control signal
to CTRL is supplied to this pin. By-
passing on this pin is not required in
this mode.
Note 1: All RF pins must be DC blocked with an external series
capacitor or held at 0 VDC.
PE4239
Product Specification
Table 3. Absolute Maximum Ratings
Symbol Parameter/Conditions Min Max
VDD Power supply voltage
-0.3 4.0
VI Voltage on any input
-0.3
VDD+
0.3
TST
TOP
PIN
VESD
Storage temperature
range
Operating temperature
range
Input power (50Ω)
ESD voltage (Human
Body Model)
-65 150
-55 85
30
1500
Units
V
V
°C
°C
dBm
V
Table 4. DC Electrical Specifications
Parameter
VDD Power Supply
Voltage
IDD Power Supply Current
(VDD = 3V, VCTRL = 3V)
Control Voltage High
Control Voltage Low
Min
2.7
0.7x VDD
Typ Max Units
3.0 3.3
V
250 500 nA
0.3x VDD
V
V
Electrostatic Discharge (ESD) Precautions
When handling this UltraCMOS device, observe
the same precautions that you would use with
other ESD-sensitive devices. Although this device
contains circuitry to protect it from damage due to
ESD, precautions should be taken to avoid
exceeding the specified rating.
Latch-Up Avoidance
Unlike conventional CMOS devices, UltraCMOS
devices are immune to latch-up.
©2002-2016 Peregrine Semiconductor Corp. All rights reserved.
Page 2 of 9
Document No. DOC-56568-2 UltraCMOS® RFIC Solutions


Part Number PE4239
Description SPDT UltraCMOS RF Switch
Maker Peregrine Semiconductor
Total Page 9 Pages
PDF Download

PE4239 Datasheet PDF

View PDF for Mobile








Similar Datasheet

1 PE4230 SPDT High Power UltraCMOS RF Switch
Peregrine Semiconductor
2 PE4231 SPDT High Power UltraCMOS
Peregrine Semiconductor
3 PE4232 SPST CATV UltraCMOS Switch
Peregrine Semiconductor
4 PE423422 SPDT RF Switch
Peregrine Semiconductor
5 PE4235 SPDT UltraCMOS RF Switch DC
Peregrine Semiconductor
6 PE42359 SPDT UltraCMOS RF Switch
Peregrine Semiconductor
7 PE423641 SP4T RF Switch
Peregrine Semiconductor
8 PE4237 SPDT UltraCMOS RF Switch DC
Peregrine Semiconductor
9 PE4239 SPDT UltraCMOS RF Switch
Peregrine Semiconductor





Part Number Start With

0    1    2    3    4    5    6    7    8    9    A    B    C    D    E    F    G    H    I    J    K    L    M    N    O    P    Q    R    S    T    U    V    W    X    Y    Z

Site map

Webmaste! click here

Contact us

Buy Components

Privacy Policy