ST24C02 Datasheet | STMicroelectronics

ST24/25C02, ST24C02R ST24/25W02 SERIAL 2K (256 x 8) EEPROM NOT FOR NEW DESIGN 1 MILLION ERASE/WRITE CYCLES with 40 YEARS DATA RETENTION SINGLE SUPPLY VOLTAGE: - 3V to 5.5V for ST24x02 versions - 2.5V to 5.5V for ST25x02 versions - 1.8V to 5.5V for ST24C02R version only HARDWARE WRITE CONTROL VERSIONS: ST24W02 and ST25W02 TWO WIRE SERIAL INTERFACE, FULLY I2C BUS PATIBLE BYTE and MULTIBYTE WRITE (up to 4 BYTES) PAGE WRITE (up to 8 BYTES) BYTE, RANDOM and SEQUENTIAL READ MODES SELF TIMED PROGRAMMING CYCLE AUTOMATIC ADDRESS INCREMENTING ENHANCED ESD/LATCH-UP PERFORMANCES ST24C/W02 are replaced by the M24C02 ST25C/W02 are replaced by the M24C02-W ST24C02R is replaced by the M24C02-R DESCRIPTION This specification covers a range of 2K bits I2C bus EEPROM products, t he ST24/25C02, the ST24C02R and ST24/25W02. In the text, products are referred to as ST24/25x02, where "x" is: "C" for Standard version and "W" for hardware Write Control version. Table 1. Signal Names E0-E2 SDA SCL MODE WC VCC VSS November 1997 This is information on a product still in production but not remended for new design 8 1 PSDIP8 (B) 0.25mm Frame 8 1 SO8 (M) 150mil Width Figure 1. Logic Diagram 3 E0-E2 SCL MODE/WC- ST24x02 ST25x02 ST24C02R SDA Chip Enable Inputs Serial Data Address Input/Output Serial Clock Multibyte/Page Write Mode (C version) Write Control (W version) Supply Voltage Ground Note: WC signal is only available for ST24/25W02 products. AI00788D 1/16 ST24/25C02, ST24C02R, ST24/25W02 Figure 2A. DIP Pin Connections Figure 2B. SO Pin Connections ST24x02 ST25x02 ST24C02R E0 E1 E2 VSS 1 2 3 4 8 7 6 5 AI00789D ST24x02 ST25x02 ST24C02R VCC MODE/WC SCL SDA E0 E1 E2 VSS 1 2 3 4 8 7 6...