OPL550 Datasheet | TT Electronics

Features : - Choice of four output options in low-cost side-looking package - Choice of two sensitivity options (OPL560/561/562/563) - High noise immunity - Direct TTL/LSTTL CMOS interface - Data rates to 250 k Baud for all except OPL560 series (200 k Baud) - Low power consumption Ro HS Description : All ponents in this series include a photodiode, amplifier, voltage regulator, Schmitt trigger and NPN output transistor on a single silicon chip. OPL560 chips also include a voltage regulator on the chip. All devices in the series have a Photologic® chip that is encapsulated in a molded plastic side-looking package with an integral lens (recessed integral lens for OPL535 and OPL536). This packaging provides enhanced optical coupling, bined with mechanical protection. The hysteresis characteristics of the Schmitt trigger on each device offers high immunity to noise on input and VCC. OPL530, OPL531, OPL535 and OPL536 include a 10 K Ω pull-up resistor (RL) from output to VCC. These ponents exhibit very stable performance over supply voltages ranging from 4.5 V to 16 V and a wide range of irradiance levels. OPL550 and OPL551 devices feature TTL/LSTTL patible logic level output which can drive up to 8 TTL loads without additional circuitry and medium-speed data rates to 250 k Baud, with typical rise and fall times of 25 nanoseconds. OPL560, OPL561, OPL562 and OPL563 devices feature TTL/LSTTL patible logic level output which can drive up to 10 TTL loads over supply voltages ranging from 4.5 V to 16 V. OPL530, OPL531, OPL550, OPL551, OPL560, OPL561, OPL562 and OPL563 are mechanically and spectrally matched to OP140 and OP240 LEDs. OPL535 and OPL536 are mechanically and spectrally matched to OP145 and OP245 series LEDs. Applications: - Non-contact reflective object sensor - Assembly line automation - Machine automation - Machine safety - End of travel sensor - Door sensor Base Part Number OPL530, OPL530-OC OPL531A, OPL531-OCA OPL535A, OPL535B OPL536A, OPL536-OC, OPL536-OCA...