NCP392A Datasheet (ON Semiconductor) - Adjustable Front End Overvoltage Protection Controller

NCP392A, Adjustable Front End Overvoltage Protection Controller

123 4 A /EN OUT OUT PGND B VBUS OUT IN PGND _D C OVLO IN IN PGND (Top View) Figure 3.

Pinout Table 1.

NCP392 PIN DESCRIPTION Pin Pin Name Type Description A1 EN I/O Enable pin bar.

The device enters in shutdown mode when this pin is tied to a high level.

In this case the outpu

NCP392A Adjustable Front End Overvoltage Protection Controller with Protected Vbus Output The NCP392A is an overvoltage front end protection and be able to disconnect the systems from its output pin in case wrong input operating conditions are detected, up to +28 V.

Due to this device using internal NMOS, no external device is necessary, reducing the system cost and the PCB area of the application board.

Internal OVLO threshold is available, or can be adjusted if external resistor bridge is use

NCP392A Features

* Over

* voltage Protection Up to + 28 V

* On

* chip Low RDS(on) NMOS Transistors: Typical 34 mW

* Over

* voltage Lockout (OVLO)

* Externally Adjustable OVLO

* Protected VBUS Indicator Output VBUS_DET

* Internal 15 ms Startup Delay