ACS755SCB-050-PSF Datasheet | Allegro MicroSystems

ACS755x CB-050 Fully Integrated, Hall Effect-Based Linear Current Sensor IC with High Voltage Isolation and a Low-Resistance Current Conductor Features and Benefits - Monolithic Hall IC for high reliability - Single +5 V supply - 3 k VRMS isolation voltage between terminals 4/5 and pins 1/2/3 for up to 1 minute - 18 k Hz bandwidth - Automotive temperature range - End-of-line factory-trimmed for gain and offset - Ultra-low power loss: 100 μΩ internal conductor resistance - Ratiometric output from supply voltage - Extremely stable output offset voltage - Small package size, with easy mounting capability - Output proportional to DC currents Package: 5 pin package (leadform PFF) Description The Allegro ACS755 family of current sensor ICs provides economical and precise solutions for DC current sensing in industrial, automotive, mercial, and munications systems. The device package allows for easy implementation by the customer. Typical applications include motor control, load detection and management, power supplies, and overcurrent fault protection. The device consists of a precision, low-offset linear Hall circuit with a copper conduction path located near the die. Applied current flowing through this copper conduction path generates a magnetic field which the Hall IC converts into a proportional voltage. Device accuracy is optimized through the close proximity of the magnetic signal to the Hall transducer. A precise, proportional voltage is provided by the low-offset, chopper-stabilized Bi CMOS Hall IC, which is programmed for accuracy at the factory. The output of the device will be valid when a current flows through the primary copper conduction path from terminal 4 to terminal 5, which is the path used for current sampling. The internal resistance of this conductive path is 100 μΩ typical, providing low power loss. Continued on the next page… ACS755050-DS Rev. 11 Typical Application 4 IP+ 1 VCC ACS755 GND 2 IP- VIOUT +5 V CBYP 0.1...