EL1503C Datasheet | Elantec

- Product Brief - Product Brief High Power Differential Line Driver Features - High power ADSL driver - 39.2VP-P differential output drive into 22Ω - 42.4VP-P differential output drive into 65Ω - Driver 2nd/3rd harmonics of -66d Bc/-72d Bc at 2VP-P into 100Ω differential - Supply current of 12.5m A per amplifier - Supply current control - Power saving modes - Standard surface-mount packages - Ultra-small LPP package General Description The EL1503C ADSL Line Driver contains two wideband high-voltage drivers which are ideally suited for both ADSL and HDSL2 applications. They can supply a 39.2V P-P signal into a 22 Ω load while exhibiting very low distortion. The EL1503C also has a number of power saving Features . The IADJ pin can be used to set the maximum supply current and the C0 and C1 pins can be used to digitally vary the supply current to one of four modes. These modes include full power, low power, terminate only and power down. Applications - ADSL line drivers - HDSL2 line drivers - Video distribution amplifiers Ordering Information Part No. EL1503CL EL1503CL-T7 Package Tape & Reel 24-Pin LPP 24-Pin LPP 24-Pin LPP EL1503CL-T13 EL1503CM EL1503CM-T13 EL1503CS EL1503CS-T7 EL1503CS-T13 d n e ns m ig C m s A o e 3 c D 0 e 5 R w 1 ot Ne EL N or e f Us Pin Configurations 24 VOUTA 7” MDP0046 MDP0046 13” 20-Pin SO (0.300") 20-Pin SO (0.300") MDP0027 d e The EL1503C uses current-feedback type amplifiers, which achieve a high slew rate while consuming moderate power. They retain their frequency response over a wide range of externally set gains. The EL1503C operates on ±5V to ±12V supplies and consumes only 12.5m A per amplifier. The device is supplied in a standard form-factor 20-pin SO (0.300"), 16-pin thermal SO (0.150”), and the small footprint (4x5mm) 24-pin LPP packages. Center pins on each side of the 20-pin and 16-pin packages are used as ground connections and heat spreaders. The LPP package has the potential for a low θJA (<40°C/W) and...