56F8027 Datasheet | Freescale Semiconductor

description of the TMS signal in Table 2-3: Note: Always tie the TMS pin to VDD through a 2.2K resistor. - Changed the description of the GPIOC4 signal in Table 2-3 (was “...the signal goes to both the ANA0 and CMPAI3”, is “...the signal goes to both ANB0 and CMPB13”). Rev. 4 - Changed the ITCN_BASE address In Table 5-3 (was $00 F060, is $00 F0E0). - In Figure 5-10, moved the footnote marker (superscript 1) from bit 4 to “RESET”. - Changed the STANDBY > STOP IDD values in Table 10-6 as follows: Typical: was 290μA, is 540μA Maximum: was 390μA, is 650μA - Changed the POWERDOWN IDD values in Table 10-6 as follows: Typical: was 190μA, is 440μA Maximum: was 250μA, is 550μA - Changed footnote 1 in Table 10-12 (was “Output frequency after application of 8MHz trim value, at 125°C.”, is “Output frequency after application of factory trim”). - Deleted the text “at 125°C” from Figure 10-5. - Changed the maximum input offset voltage in Table 10-21 (was +/- 20 m V, is ±35 m V). Rev. 5 - In Table 2-3, changed VCAP value from 4.7μF to 2.2μF. - Revised Section 7, Security Features . - Added information for 56F8027 device throughout document. - Fixed miscellaneous typos. Description of Change 56F8037/56F8027 Data Sheet, Rev. 6 2 Freescale Semiconductor .. Document Revision History Version History Rev. 6 Description of Change In the table Remended Operating Conditions, removed the line “XTAL not driven by an external clock“ from the characteristic: “Oscillator Input Voltage High XTAL not driven by an external clock XTAL driven by an external clock source” In the table 56F8037/56F8027 Ordering Information, changed “MC56F8027VLD“ to “MC56F8027VLH“ Removed “Preliminary” from data sheet In the Select Peripheral Input Source for PWM2/PWM3 Pair Source Bits, fixed typos Added new part number to ordering information: MC56F8027MLH Please see http://.freescale. for the most current data sheet revision. 56F8037/56F8027 Data Sheet, Rev. 6 Freescale Semiconductor 3 .. 56F8037/56F8027 General...