GD25Q10
Overview
The GD25Q40/20/10/512 (4M-bit) SPI flash supports the standard Serial Peripheral Interface (SPI), and a high performance Dual/Quad output as well as Dual/Quad SPI: Serial Clock, Chip Select, Serial Data I/O0 (SI), I/O1 (SO), I/O2 (WP#), and I/O3 (HOLD#). SPI clock frequencies of up to 120MHz are supported allowing equivalent clock rates of 240MHz for Dual Output & Dual I/O read command, and 480MHz for Quad output & Quad I/O read command.
- 4M/2M/1M/512K-bit Serial Flash -512/256/128/64K-byte -256 bytes per programmable page
- Standard, Dual, Quad SPI -Standard SPI: SCLK, CS#, SI, SO, WP#, HOLD# -Dual SPI:SCLK, CS#, IO0, IO1, WP#, HOLD# -Quad SPI:SCLK, CS#, IO0, IO1, IO2, IO3
- High Speed Clock Frequency -120MHz for fast read with 30PF load -Dual I/O Data transfer up to 240Mbits/s -Quad I/O Data transfer up to 480Mbits/s
- Program/Erase Speed -Page Program time:0.7ms typical -Sector Erase time:150ms typical -Block Erase time:0.3\0.5s typical -Chip Erase time:3\2\1\0.5s typical
- Flexible Architecture -Sector of 4K-byte -Block of 32/64K-byte
- Low Power Consumption -20mA maximum active current -5uA maximum power down current
- Software/Hardware Write Protection
- Advanced security Features(1) -Write protect all/portion of memory via software -16-Bit Customer ID -Enable/Disable protection with WP# Pin -Security Architecture -Top or Bottom, Sector or Block selection
- Single Power Supply Voltage
- Minimum 100,000 Program/Erase Cycles -Full voltage range:2.7~3.6V Note: contact Gigadevice for details.
