MAX3349E Datasheet | Maxim Integrated

Description The MAX3349E ±15k V ESD-protected, USB transceiver provides a full-speed USB interface to a lower voltage microprocessor or ASIC. The device supports enumeration, suspend, and VBUS detection. A special UART multiplexing mode routes external UART signals (Rx and Tx) to D+ and D-, allowing the use of a shared connector to reduce cost and part count for mobile devices. The UART interface allows mobile devices such as PDAs, cellular phones, and digital cameras to use either UART or USB signaling through the same connector. The MAX3349E features a separate UART voltage supply input to support legacy devices using +2.75V signaling. The MAX3349E supports a maximum UART baud rate of 921kbaud. Upon connection to a USB host, the MAX3349E enters USB mode and provides a full-speed USB 2.0 pliant interface through VP, VM, RCV, and OE. The MAX3349E features internal series termination resistors on D+ and D-, and an internal 1.5kΩ pullup resistor to D+ to allow the device to logically connect and disconnect from the USB while plugged in. A suspend mode is provided for low-power operation. D+ and D- are protected from electrostatic discharge (ESD) up to ±15k V. The MAX3349E is available in 16-pin TQFN (4mm x 4mm) and 16-bump UCSP™ (2mm x 2mm) packages, and is specified over the -40°C to +85°C extended temperature range. Features - ±15k V ESD HBM Protection on D+ and D- UART Mode Routes External UART Signals to D+/D- Internal Linear Regulator Allows Direct Powering from the USB Cable - Separate Voltage Input for UART Transmitter/Receiver (VUART) - Internal 1.5kΩ Pullup Resistor on D+ Controlled by Enumerate Input - Internal Series Termination Resistors on D+ and D- plies with USB Specification Revision 2.0, Full-Speed 12Mbps Operation - Built-In Level Shifting Down to +1.4V, Ensuring patibility with Low-Voltage ASICs - VBUS Detection - bined VP and VM Inputs/Outputs - No Power-Supply Sequencing Required - Available in 16-Bump UCSP (2mm x 2mm) Package Ordering...