AMIS-41683 Datasheet | onsemi

Description The new AMIS- 41682 and AMIS- 41683 are interfaces between the protocol controller and the physical wires of the bus lines in a control area network (CAN). AMIS- 41683 is identical to the AMIS- 41682 but has a true 3.3 V digital interface to the CAN controller. The device provides differential transmit capability but will switch in error conditions to a single- wire transmitter and/or receiver. Initially it will be used for low speed applications, up to 125 k B, in passenger cars. Both AMIS- 41682 and AMIS- 41683 are implemented in I2T100 technology enabling both high- voltage analog circuitry and digital functionality to co- exist on the same chip. These products consolidate the expertise of ON Semiconductor for in- car multiplex transceivers and support together with 0REMX- 002- XTP (VAN), AMIS- 30660 and AMIS- 30663 (CAN high speed) and AMIS- 30600 (LIN) another widely used physical layer. .onsemi. PIN ASSIGNMENT INH 1 Tx D 2 Rx D 3 ERR 4 STB 5 AMIS- 4168x 14 VBAT 13 GND 12 CANL 11 CANH 10 VCC Features - Fully patible with ISO11898- 3 Standard EN 6 9 RTL - Optimized for In- Car Low- speed munication WAKE 7 8 RTH - Baud Rate up to 125 k B - Up to 32 Nodes can be Connected - Due to Built- in Slope Control function and a very Good Matching (Top View) PC20041029.1 of the CANL and CANH bus outputs, this device realizes a very low electromagnetic emission (EME) - Fully Integrated Receiver Filters ORDERING INFORMATION See detailed ordering and shipping information in the package dimensions section on page 14 of this data sheet. - Permanent Dominant Monitoring of Transmit Data Input - Differential Receiver with Wide mon- Mode - Protection Issues Range for High Electromagnetic Susceptibility - Short Circuit Proof to Battery and Ground (EMS) in Normal- and Low- Power Modes - Thermal Protection - True 3.3 V Digital I/O Interface to CAN Controller for AMIS- 41683 Only - Management in Case of Bus Failure - The Bus Lines are Protected Against Transients in an...