Datasheet4U Logo Datasheet4U.com

NCP392B - Adjustable Front End Overvoltage Protection Controller

Description

(Top View) Figure 3.

Table 1.

I/O Enable pin bar.

Features

  • Over.
  • voltage Protection Up to + 28 V.
  • On.
  • chip Low RDS(on) NMOS Transistors: Typical 34 mW.
  • Over.
  • voltage Lockout (OVLO).
  • Externally Adjustable OVLO (A Version).
  • Protected VBUS Indicator Output VBUS_DET.
  • Internal 15 ms Startup Delay.
  • 100 ms Start Up Delay Option (B Version).
  • Shutdown EN Input.
  • + 100 V Surge Capability, in Compliance with IEC61000.
  • 4.
  • 5 Standard.
  • Complian.

📥 Download Datasheet

Datasheet preview – NCP392B

Datasheet Details

Part number NCP392B
Manufacturer ON Semiconductor
File Size 217.73 KB
Description Adjustable Front End Overvoltage Protection Controller
Datasheet download datasheet NCP392B Datasheet
Additional preview pages of the NCP392B datasheet.

📁 Similar Datasheet

Other Datasheets by ON Semiconductor
  • NCP392A - Adjustable Front End Overvoltage Protection Controller
  • NCP392D - Adjustable Front End Overvoltage Protection Controller
  • NCP391 - Positive Overvoltage Protection Controller
  • NCP398 - USB Type-C VCONN Overvoltage Protection IC
  • NCP3985 - Ultra-Low Dropout BiCMOS Voltage Regulator
  • NCP300 - Voltage Detector
  • NCP301 - Voltage Detector
  • NCP3011 - Synchronous PWM Controller

Full PDF Text Transcription

Click to expand full text
NCP392B Adjustable Front End Overvoltage Protection Controller with Protected Vbus Output The NCP392B is an overvoltage front end protection and be able to disconnect the systems from its output pin in case wrong input operating conditions are detected, up to +28 V. Due to this device using internal NMOS, no external device is necessary, reducing the system cost and the PCB area of the application board. Internal OVLO threshold is available, or can be adjusted if external resistor bridge is used (A version). At power up (EN pin = low level), the Vout turns on tstart time after internal timer elapsed. Additional timer option is available in the B version for OTG supporting.
Published: |