NLAS4051S - Analog Multiplexer/Demultiplexer

onsemi

Key Features

Improved RDS(on) Specifications.
Pin for Pin Replacement for MAX4051 and MAX4051A.
One Half the Resistance Operating at 5.0 V.
Single or Dual Supply Operation.
Single 2.5.
5.0 V Operation, or Dual ±3.0 V Operation.
With VCC of 3.0 to 3.3 V, Device Can Interface with 1.8 V Logic, No Translators Needed.
Address and Inhibit Logic are Over.
Voltage Tolerant and May Be Driven Up +6.0 V Regardless of VCC.
Improved L.

NLAS4051S analog multiplexer/demultiplexer by onsemi - Datasheet Preview

Datasheet Details

Part number	NLAS4051S
Manufacturer	onsemi
File Size	219.43 KB
Description	Analog Multiplexer/Demultiplexer
Datasheet	NLAS4051S Datasheet

📁 Similar Datasheet

Part Number	Description	Manufacturer
NLAS4053	Analog Multiplexer/Demultiplexer	ON
NLAS4599	Low Voltage Single Supply SPDT Analog Switch	ON
NLAS4684	Ultra-Low Resistance Dual SPDT Analog Switch	ON
NLAS2750	Low Voltage Dual SPDT Analog Switch	ON Semiconducto
NLAS323	Dual SPST Analog Switch	ON

Other Datasheets by onsemi

Part Number	Description
NLAS4051	Analog Multiplexer/Demultiplexer
NLAS4052	Analog Multiplexer/Demultiplexer
NLAS4157	SPDT / 1 ohm RON Switch
NLAS44599	Low Voltage Single Supply Dual DPDT Analog Switch
NLAS4501	Single SPST Analog Switch

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text

NLAS4051S Analog Multiplexer/ Demultiplexer TTL Compatible, Single−Pole, 8−Position Plus Common Off The NLAS4051S is an improved version of the MC14051 and MC74HC4051 fabricated in sub−micron Silicon Gate CMOS technology for lower RDS(on) resistance and improved linearity with low current. This device may be operated either with a single supply or dual supply up to ±3.0 V to pass a 6.0 VPP signal without coupling capacitors. When operating in single supply mode, it is only necessary to tie VEE, pin 7 to ground. For dual supply operation, VEE is tied to a negative voltage, not to exceed maximum ratings. Features • Improved RDS(on) Specifications • Pin for Pin Replacement for MAX4051 and MAX4051A ♦ One Half the Resistance Operating at 5.0 V • Single or Dual Supply Operation ♦ Single 2.5−5.