PT5616A Datasheet | PTC

DESCRIPTION The devices are full bridge drivers to control power devices like MOS-transistors or IGBTs in 3-phase systems with a maximum blocking voltage of +600 V. The six independent drivers are controlled at the low-side using CMOS and LSTTL patible signals, down to 3.3V logic. The device includes an under -voltage detection unit with hysteresis characteristic and over -current detection. The over -current level is adjusted by choosing the resistor value and the threshold level at pin ITRIP. Both error conditions (under-voltage and over-current) lead to a definite shut down of all six switches. An error signal is provided at the FAULT open drain output pin. The blocking time after over -current can be adjusted with an RC-network at pin RCIN. Therefore, the resistor RRCIN is optional. The typical output current can be given with 200m A for pull-up and 400m A for pull down. Because of system safety reasons a 0.29us dead time has been realized. The function of inputs EN and ITRIP can optionally be extended with over-temperature detection, using an external NTC resistor, diodes and resistor network. APPLICATIONS - Three phase motor drives - Industrial inverters. - General purpose three phase inverters PT5616/PT5616A 3-Phase 600V Gate Driver IC Features - Drives up to six IGBT/MOSFET power devices - All high side channels fully operate up to +600V - Gate drive supplies up to 18 V per channel - Under-voltage lockout for all channels - Over-current protection - Flexible over-temperature shutdown input - Advanced input filter - Built-in dead-time protection - Shoot-through (cross-conduction) protection - Independent Enable/disable input and fault reporting - Shutdown all switches during error conditions - Adjustable fault clear timing - Separate logic and power grounds - 3.3 V/5V input logic patible - Designed for use with bootstrap power supplies - Matched propagation delays for all channels - Matched dead time - -40°C to 125°C operating range - SOP28 Package...