Datasheet4U Logo Datasheet4U.com

X93156 - Single Digitally Potentiometer

General Description

INC Increment (INC).

The INC input is negative-edge triggered.

Key Features

  • Solid-state potentiometer.
  • Up/Down interface.
  • 32 wiper tap points - Wiper position stored in nonvolatile memory and recalled on power-up.
  • 31 resistive elements - Temperature compensated - Maximum resistance tolerance of ±25% - Terminal voltage, 0 to VCC.
  • Low power CMOS - VCC = 2.7V to 5.5V - Active current, 200µA typ. - Standby current, 2µA max.
  • High reliability - Endurance 200,000 data changes per bit - Register data retention, 100 years.

📥 Download Datasheet

Datasheet Details

Part number X93156
Manufacturer Renesas
File Size 397.34 KB
Description Single Digitally Potentiometer
Datasheet download datasheet X93156 Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
X9312 Terminal Voltage 0V to 15V Intersil Corporation
X930A UNIVERSAL SERIAL BUS MICROCONTROLLER Intel Corporation

Other Datasheets by Renesas

Part Number Description
X9315 Digitally Potentiometer
X93154 Digitally Potentiometer
X93155 Digitally Potentiometer
X9313 Digitally Controlled Potentiometer
X9314 Single Digitally Potentiometer

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
DATASHEETNOT RECOMMENDED FOR NEW DESIGNS NO RECOMMENDED REPLACEMENT X93156 contact our Technical Support Center at 1-888-INTERSIL or www.intersil.com/tsc FN8182 Single Digitally Controlled Potentiometer (XDCP™) Low Noise, Low Power, 3 wire Rev 3.00 Up/Down, 32 Taps November 21, 2007 The Intersil X93156 is a three-terminal digitally controlled potentiometer (XDCP). The device consists of a resistor array, wiper switches, a control section, and nonvolatile memory. The wiper position is controlled by an Up/Down interface. The potentiometer is implemented by a resistor array composed of 31 resistive elements and a wiper switching network. The position of the wiper element is controlled by the CS, U/D, and INC inputs.