X93155 - Digitally Potentiometer

Datasheet Summary

Description

1 INC Increment (INC).

The INC input is negative-edge triggered.

Toggling INC will move the wiper and either increment or decrement the counter in the direction indicated by the logic level on the U/D input.

Features

Solid-state potentiometer.
Up/Down interface.
32 wiper tap points per potentiometer - Wiper position stored in nonvolatile memory and recalled on power-up.
31 resistive elements per potentiometer - Temperature compensated - Maximum resistance tolerance ±25% - Terminal voltage, 0 to VCC.
Low power CMOS - VCC = 5V ±10% - Active current, 200µA typ. - Standby current, 2.0µA max.
High reliability - Endurance 200,000 data changes per bit - Regist.

Renesas

📥 Download Datasheet

Datasheet Details

Part number	X93155
Manufacturer	Renesas
File Size	429.83 KB
Description	Digitally Potentiometer
Datasheet	X93155 Datasheet
Additional preview pages of the X93155 datasheet.

📁 Similar Datasheet

X9312 - Terminal Voltage 0V to 15V (Intersil Corporation)
X930A - UNIVERSAL SERIAL BUS MICROCONTROLLER (Intel Corporation)

Other Datasheets by Renesas

X9315 - Digitally Potentiometer
X93154 - Digitally Potentiometer
X93156 - Single Digitally Potentiometer
X9313 - Digitally Controlled Potentiometer
X9314 - Single Digitally Potentiometer
X9317 - Digitally Controlled Potentiometer
X9318 - Digitally Potentiometer
X9319 - Digitally Potentiometer

Full PDF Text Transcription

Click to expand full text

X93155 NOT RECOMMENDED FOR NEW DESIGNS NO RECOMMENDED REPLACEMENT contact our Technical Support Center at 1-888-INTERSIL or www.intersil.com/tsc Digitally Controlled Potentiometer (XDCP™) DATASHEET FN8181 Rev 2.00 February 19, 2008 The Intersil X93155 is a digitally controlled potentiometer (XDCP). The device consists of a resistor array, wiper switches, a control section, and nonvolatile memory. The wiper position is controlled by a 3-wire interface. The potentiometer is implemented by a resistor array composed of 31 resistive elements and a wiper switching network. The position of the wiper element is controlled by the CS, U/D, and INC inputs. The position of the wiper can be stored in nonvolatile memory and then be recalled upon during a subsequent power-up operation.

Published: Jun 3, 2020 |