THCV242 Datasheet | THine Electronics

THCV242_ Rev.1.00_E Ser Des receiver with bi-directional transceiver 1. General Description THCV242 is designed to support 1080p60 2Mpixel unpressed video data over 15m 100ohm differential STP or single-end 50ohm Coaxial cable with 4 in-line connectors between camera and processor by V-by-One® HS. THCV242 supports a MIPI CSI-2. Each CSI-2 data lane can transmit up to 1.2Gbps/lane. Virtual channel is supported. MIPI 2nd port output supports data copy and distribution. One high-speed V-by-One® HS lane can transmit up to 1080p60fps. The maximum serial data rate is 4Gbps/lane. 2nd input lane supports HDR large amount of data or camera switch experience. THCV242 is capable to control and monitor remote camera module from MPU via GPIO or 1Mbps 2wire serial interface. Several fault and error detection function including CRC provides hardware functional safety design. 3. Block Diagram 2. Features - MIPI CSI-2 with 1,2 or 4-lane output - MIPI D-PHY supports 80Mbps~1.2Gbps - MIPI Virtual channel supported - Video formats: RAW8/10/12/14/16/20, YUV422/420, RGB888/666/565, JPEG, Userdefined generic 8-bit - V-by-One® HS 400Mbps~4Gbps x2lane - V-by-One® HS standard version1.5 - Video stream switch and copy/distribution - Frame sync remote supply scheme for multiple camera stream synchronization - Wide range IO voltage from 1.7V to 3.6V - 2-wire serial interface 1Mbps bridge function - Remote GPIO/UART control and monitoring - Error detection including CRC and notification - QFN64 9x9mm 0.5mm pitch Exp-pad package V-by-One® HS Main-Link Rx 2-lane RX0P RX0N RX1P RX1N Sub-Link 2-lane RCM0P RCM0N Deserializer CSI2 / Formatter MIPI CSI-2 Data Tx 4-lane Clock Tx...