THCV241A Datasheet | THine Electronics

THCV241A_Rev.1.00_E Ser Des transmitter with bi-directional transceiver 1 General Description THCV241A is designed to support 1080p60 2Mpixel unpressed video data over 15m 100ohm differential STP or single-end 50ohm Coaxial cable with 4 in-line connectors between camera and processor by V-by-One® HS. THCV241A supports a MIPI CSI-2. Each CSI-2 data lane can transmit up to 1.2Gbps/lane. Virtual channel is supported. One high-speed V-by-One® HS lane can transmit up to 1080p60fps. The maximum serial data rate is 4Gbps/lane. 2nd output lane supports HDR large amount of data or data copy-and-distribution experience. THCV241A is capable to control and monitor camera module from remote ECU via GPIO, UART or 1Mbps 2-wire serial interface. Several fault and error detection function including CRC provides hardware functional safety design. 2 Features - MIPI CSI-2 with 1,2 or 4-lane input - MIPI D-PHY supports 80Mbps~1.2Gbps - MIPI Virtual channel supported - Video formats: RAW8/10/12/14/16/20, YUV422/420, RGB888/666/565, JPEG, Userdefined generic 8-bit - V-by-One® HS 400Mbps~4Gbps x2lane - V-by-One® HS standard version1.5 - Reference clock input CKI range 10~40MHz shareable with video source CMOS sensor - Wide range IO voltage from 1.7V to 3.6V - Additional spread spectrum to reduce EMI - 2-wire serial interface 1Mbps bridge function - Remote GPIO/UART control and monitoring - Error detection including CRC and notification - QFN40 5x5mm 0.4mm pitch Exp-pad package 3 Block Diagram MIPI CSI-2 Rx 4-lane RD3p RD3n RD1p RD1n RCKp RCKn RD0p RD0n RD2p...