AT91SAM9G46
AT91SAM9G46 is AT91 ARM Thumb-based Microcontrollers manufactured by Atmel.
Features
- 400 MHz ARM926EJ-S™ ARM® Thumb® Processor
- 32 KBytes Data Cache, 32 KBytes Instruction Cache, MMU
- Memories
- 4-port, 4-bank DDR2/LPDDR Controller
- External Bus Interface supporting 4-bank DDR2/LPDDR, SDRAM/LPSDR, Static Memories, pact Flash, SLC NAND Flash with ECC
- One 64-KByte internal SRAM, single-cycle access at system speed or processor speed through TCM interface
- One 64-KByte internal ROM, embedding bootstrap routine Peripherals
- LCD Controller supporting STN and TFT displays up to 1280- 860
- ITU-R BT. 601/656 Image Sensor Interface
- Dual High Speed USB Host and a High Speed USB Device with On-Chip Transceivers
- 10/100 Mbps Ethernet MAC Controller
- Two High Speed Memory Card Hosts (SDIO, SDCard, e.MMC and CE ATA)
- AC'97 controller
- Two Master/Slave Serial Peripheral Interfaces
- Two Three-channel 16-bit Timer/Counters
- Two Synchronous Serial Controllers (I2S mode)
- Four-channel 16-bit PWM Controller
- Two Two-wire Interfaces
- Four USARTs with ISO7816, Ir DA, Manchester and SPI modes
- 8-channel 10-bit ADC with 4-wire Touch Screen support Cryptography
- TRNG True Random Number Generator
- AES256-, 192-, 128-bit Key Algorithm,
- TDES pliant with FIPS PUB 46-3 Specifications
- SHA (SHA1 and SHA256) pliant with FIPS Publication 180-2 System
- 133 MHz twelve 32-bit layer AHB Bus Matrix
- 39 DMA Channels
- Boot from NAND Flash, SDCard, Data Flash® or serial Data Flash
- Reset Controller with on-chip Power-on Reset
- Selectable 32768 Hz Low-power and 12 MHz Crystal...
