Datasheet4U Logo Datasheet4U.com

TDA8592Q - (TDA8592J/Q) I2C Bus Controlled 4 x 50W Power Amplifier

Download the TDA8592Q datasheet PDF. This datasheet also covers the TDA8592J variant, as both devices belong to the same (tda8592j/q) i2c bus controlled 4 x 50w power amplifier family and are provided as variant models within a single manufacturer datasheet.

Description

The TDA8592J; TDA8592Q is a complementary quad BTL audio power amplifier made in the BCDMOS technology.

It contains four independent amplifiers in Bridge Tied Load (BTL) configuration.

Through the I2C-bus the diagnostic information of each amplifier and speaker can be read separately.

Features

  • s I2C-bus control s Hardware programmable I2C-bus address s Can drive a 2 Ω load with a battery voltage of up to 16 V and a 4 Ω load with a battery voltage of up to 18 V s DC-load detection: open, short and present s AC-load (tweeter) detection s Programmable clip detection: 1 % or 3 % s Programmable thermal protection pre-warning s Independent short-circuit protection per channel s Low gain line driver mode (20 dB) s Loss-of-ground and open VP safe s All outputs protected from short-circuit to.

📥 Download Datasheet

Note: The manufacturer provides a single datasheet file (TDA8592J_PhilipsSemiconductors.pdf) that lists specifications for multiple related part numbers.

📁 Similar Datasheet

Part Number Description Manufacturer
TDA8595 I2C-bus controlled 4 x 45 W power amplifer NXP Semiconductors
TDA8547 2 x 0.7W BTL AUDIO AMPLIFIER UTC
TDA8559T Low-voltage stereo headphone amplifier Philips
TDA8566 stereo BTL car radio power amplifier NXP Semiconductors
TDA8577 Dual common-mode rejection differential line receiver Philips

Other Datasheets by NXP Semiconductors

Part Number Description
TDA8592J (TDA8592J/Q) I2C Bus Controlled 4 x 50W Power Amplifier
TDA8591J 4 X 44 W into 4 or 4 X 75 W into 2 quad BTL car radio power amplifier
TDA8594 4 x 50W power amplifier
TDA8596 4 x 45 W power amplifier
TDA8501 PAL/NTSC encoder

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
www.DataSheet4U.com TDA8592J; TDA8592Q I2C-bus controlled 4 × 50 W power amplifier Rev. 01 — 8 June 2004 Preliminary data sheet 1. General description The TDA8592J; TDA8592Q is a complementary quad BTL audio power amplifier made in the BCDMOS technology. It contains four independent amplifiers in Bridge Tied Load (BTL) configuration. Through the I2C-bus the diagnostic information of each amplifier and speaker can be read separately. Both front and both rear channel amplifiers can be configured independently in line driver mode with a gain of 20 dB. 2.
Published: |