TDA8596 Datasheet 4 x 45 W power amplifier

Manufacturer: NXP Semiconductors

Datasheet Details

The TDA8596 is a quad Bridge Tied Load (BTL) audio power ampliﬁer with symmetrical inputs, made in BCDMOS technology.

It contains four independent ampliﬁer channels in BTL conﬁguration with complementary (PMOST/NMOST) output stages.

Temperature warning and output signal clipping diagnosis is possible via the I2C-bus and via the diagnostic pins (DIAG and STB pin).

TDA8596 I2C-bus controlled 4 × 45 W power ampliﬁer with symmetrical inputs Rev.

02 — 8 November 2007 Product data sheet 1.

2.1 General I Operates in legacy mode (non I2C-bus) and I2C-bus mode (3.3 V and 5 V compliant) I Three hardware-programmable I2C-bus addresses I Drives 4 Ω or 2 Ω loads I Balanced/symmetrical inputs I Speaker fault detection I Programmable gain (26 dB and 16 dB) also available in legacy mode I Independent short circuit protection per channel I Loss of ground and loss of VP safe (with 300 mΩ series impedance and a maximum supply decoupling capacitor of 2200 µF) I All outputs are short-circuit pro.

Part Number	Description
TDA8591J	4 X 44 W into 4 or 4 X 75 W into 2 quad BTL car radio power amplifier
TDA8592J	(TDA8592J/Q) I2C Bus Controlled 4 x 50W Power Amplifier
TDA8592Q	(TDA8592J/Q) I2C Bus Controlled 4 x 50W Power Amplifier
TDA8594	4 x 50W power amplifier
TDA8501	PAL/NTSC encoder
TDA8505	SECAM encoder
TDA8510J	26 W BTL and 2 x 13 W SE power amplifiers
TDA8511J	4 x 13 W single-ended power amplifiers
TDA8512J	26 W BTL and 2 x 13 W SE or 4 x 13 W SE power amplifier
TDA8540	4 X 4 video switch matrix