HIP4086A Datasheet PDF - Renesas 3-Phase MOSFET Driver Specs

HIP4086A - 3-Phase MOSFET Driver

This page provides the datasheet information for the HIP4086A, a member of the HIP4086 3-Phase MOSFET Driver family.

Datasheet Summary

Description

High-Side Bias Connections.

One external bootstrap diode and one capacitor are required for each.

Features

Independently drives 6 N-channel MOSFETs in 3-phase bridge configuration.
Bootstrap supply maximum voltage up to 95VDC with bias supply from 7V to 15V.
1.25A peak turn-off current.
User programmable dead time (0.5µs to 4.5µs).
Bootstrap and optional charge pump maintain the high-side driver bias voltage.
Programmable bootstrap refresh time.
Drives 1000pF load with typical rise time of 20ns and fall time of 10ns.
Programmab.

Datasheet Details

Part number	HIP4086A
Manufacturer	Renesas
File Size	813.16 KB
Description	3-Phase MOSFET Driver
Datasheet	HIP4086A Datasheet
Additional preview pages of the HIP4086A datasheet.

📁 Similar Datasheet

HIP4081 - 80V/2.5A Peak/ High Frequency Full Bridge FET Driver (Intersil Corporation)

HIP4011 - Three Phase Brushless DC Motor Controller (Intersil Corporation)

HIP0063 - Hex Low Side MOSFET Driver with Serial or Parallel Interface and Diagnostic Fault Control (Intersil Corporation)

HIP1030 - 1A High Side Driver with Overload Protection (Intersil Corporation)

HIP1031 - Half Amp High Side Driver with Overload Protection (Intersil Corporation)

HIP1090 - Protected High Side Power Switch with Transient Suppression (Intersil Corporation)

HIP2106 - 100V/1A Peak/ Low Cost/ High Frequency Half Bridge Driver (Intersil Corporation)

HIP2500 - Half Bridge 500VDC Driver (Harris Corporation)

HIP5010 - 7V/ 17A SynchroFET Complementary Drive Synchronous Half-Bridge (Intersil Corporation)

HIP5011 - 7V/ 17A SynchroFET Complementary Drive Synchronous Half-Bridge (Intersil Corporation)

Full PDF Text Transcription

Click to expand full text

HIP4086, HIP4086A 80V, 500mA, 3-Phase MOSFET Driver The HIP4086 and HIP4086A (referred to as the HIP4086/A) are 3-phase N-channel MOSFET drivers. Both parts are specifically targeted for PWM motor control. These drivers have flexible input protocol for driving every possible switch combination. The user can even override the shoot-through protection for switched reluctance applications. The HIP4086/A have a wide range of programmable dead times (0.5µs to 4.5µs) which makes them very suitable for the low frequencies (up to 100kHz) typically used for motor drives. The only difference between the HIP4086 and the HIP4086A is that the HIP4086A has the built-in charge pumps disabled. This is useful in applications that require very quiet EMI performance (the charge pumps operate at 10MHz).

Published: Apr 4, 2020 |