OPB916BZ Datasheet | TT Electronics

Features : - Low power consumption - Data rates to 250 k Baud - Choice of two logic states and two electrical outputs - 24” (610 mm) minimum 26 AWG UL listed wires - Slot width 0.20” (5.08 mm) - Slot Depth 0.635” (16.13 mm) Description : The OPB916 series of Photologic® photo integrated circuit switches provide optimum flexibility. Each switch consists of an infrared Light Emitting Diode (LED) and a Photologic® photo integrated circuit, mounted in an opaque housing with clear windows for dust protection. The deep slot allows for a longer reach of the optical path from the 0.650” (16.5 mm) mounting plane. Internal apertures are 0.010” x .060” (.25 mm x 1.52 mm) for the Photologic’s “S” side and 0.05” x 0.06” (1.27 mm x 1.52 mm) for the LED “E” side. Devices in this series exhibit stable performance over supply voltages ranging from 4.5 V to 16.0 V, and may be specified as buffered or inverted with an internal 10 kΩ pull-up resistor or open collector output. Devices are TTL/LSTTL patible and can drive up to 10 TTL loads. Custom electrical, wire or cabling are available. Contact your local representative or OPTEK for more information. Applications: - Mechanical switch replacement - Speed indication (tachometer) - Mechanical limit indication - Edge sensing Part Number OPB916BZ OPB916IZ OPB916BOCZ LED Peak Wavelength 880 nm Ordering Information Sensor Photologic® Slot Width / Depth 10K Pull-Up Inv-10K Pull-Up Open-Collector 0.200” / 0.635” Aperture Emitter / Sensor 0.05" / 0.01" Lead Length / Wire 24" / 26 AWG Wire Color Description Red Anode Black Cathode White Vcc Blue Output Green Ground OPB916B 10K Pull-Up Light ON output High OPB916I Inverted 10K Pull-Up Light ON output Low Ro HS General Note TT Electronics reserves the right to make changes in product specification without notice or liability. All information is subject to TT Electronics’ own data and is considered accurate at time of going to print. © TT electronics plc OPB916BOC Open-Collector Light...