DS90CR211 Datasheet | National Semiconductor

Description The DS90CR211 transmitter converts 21 bits of CMOS/TTL data into three LVDS (Low Voltage Differential Signaling) data streams. A phase-locked transmit clock is transmitted in parallel with the data streams over a fourth LVDS link. Every cycle of the transmit clock 21 bits of input data are sampled and transmitted. The DS90CR212 receiver converts the LVDS data streams back into 21 bits of CMOS/TTL data. At a transmit clock frequency of 40 MHz, 21 bits of TTL data are transmitted at a rate of 280 Mbps per LVDS data channel. Using a 40 MHz clock, the data throughput is 840 Mbit/s(105 Mbyte/s). The multiplexing of the data lines provides a substantial cable reduction. Long distance parallel single-ended buses typically require a ground wire per active signal (and have very limited noise rejection capability). Thus, for a 21-bit wide data bus and one clock, up to 44 conductors are required. With the Channel Link chipset as few as 9 conductors (3 data pairs, 1 clock pair and a minimum of one ground) are needed. This provides a 80% reduction in required cable width, providing a system cost savings, reduces connector physical size, and reduces shielding requirements due to the cables smaller form factor. The 21 CMOS/TTL inputs can support a variety of signal binations. For example, 5 4-bit nibbles plus 1 control, or 2 9-bit (byte + parity) and 3 control. Features n n n n n n n n Narrow bus reduces cable size and cost ± 1V mon mode range (ground shifting) 290 m V swing LVDS data transmission 840 Mbit/s data throughput Low swing differential current mode drivers reduce EMI Rising edge data strobe Power down mode Offered in low profile 48-lead TSSOP package Block Diagrams DS90CR211 DS90CR212 DS012637-27 DS012637-1 Order Number DS90CR211MTD See NS Package Number MTD48 Order Number DS90CR212MTD See NS Package Number MTD48 TRI-STATE ® is a registered trademark of National Semiconductor Corporation. © 1998 National Semiconductor Corporation DS012637 .national....