Datasheet4U Logo Datasheet4U.com

29F002 - 2 Mbit 256Kb x8 / Boot Block Single Supply Flash Memory

General Description

The M29F002B is a 2 Mbit (256Kb x8) non-volatile memory that can be read, erased and reprogrammed.

These operations can be performed using a single 5V supply.

On power-up the memory defaults to its Read mode where it can be read in the same way as a ROM or EPROM.

Key Features

  • iming requirements. Output Disable. The Data Inputs/Outputs are in the high impedance state when Output Enable.

📥 Download Datasheet

Datasheet Details

Part number 29F002
Manufacturer STMicroelectronics
File Size 142.47 KB
Description 2 Mbit 256Kb x8 / Boot Block Single Supply Flash Memory
Datasheet download datasheet 29F002 Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
29F002 2 Megabit (256 K x 8-Bit) CMOS 5.0 Volt-only Boot Sector Flash Memory Advanced Micro Devices
29F002 2M (256K X 8) BIT Fujitsu Media Devices Limited
29F002 2M-BIT [256K x 8] CMOS FLASH MEMORY Macronix International
29F001TPC MX29F001TPC Macronix International
29F010 1 Megabit (128 K x 8-bit) CMOS 5.0 Volt-only / Uniform Sector Flash Memory Advanced Micro Devices

Other Datasheets by STMicroelectronics

Part Number Description
29F010 1 Mbit 128Kb x8 / Uniform Block Single Supply Flash Memory
29F040 4 Mbit 512Kb x8 / Uniform Block Single Supply Flash Memory
29F160BB Boot Block Single Supply Flash Memory
29F160BT Boot Block Single Supply Flash Memory
29F200 2 Mbit 256Kb x8 or 128Kb x16 / Boot Block Single Supply Flash Memory

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
M29F002BT M29F002BB, M29F002BNT 2 Mbit (256Kb x8, Boot Block) Single Supply Flash Memory PRELIMINARY DATA s SINGLE 5V ± 10% SUPPLY VOLTAGE for PROGRAM, ERASE and READ OPERATIONS ACCESS TIME: 45ns PROGRAMMING TIME – 8µs by Byte typical 7 MEMORY BLOCKS – 1 Boot Block (Top or Bottom Location) – 2 Parameter and 4 Main Blocks PLCC32 (K) TSOP32 (N) 8 x 20mm s s s s PROGRAM/ERASE CONTROLLER – Embedded Byte Program algorithm – Embedded Multi-Block/Chip Erase algorithm – Status Register Polling and Toggle Bits 32 s ERASE SUSPEND and RESUME MODES – Read and Program another Block during Erase Suspend 1 PDIP32 (P) s UNLOCK BYPASS PROGRAM COMMAND – Faster Production/Batch Programming TEMPORARY BLOCK UNPROTECTION MODE LOW POWER CONSUMPTION – Standby and Automatic Standby VCC s Figure 1.