logo

ADM Matched Datasheet



Part Number Description Manufacture
SJ-S-112DM
(SJ-S-112DM/LM) Relays
Manufacture
ADMPEX
SJ-S-112LM
(SJ-S-112DM/LM) Relays
Manufacture
ADMPEX
ADM20N06D
N-Channel MOSFET
Manufacture
ADV
ADM250N04
N-Channel MOSFET
Manufacture
ADV
ADM485
5V Low Power EIA RS-485 Transceiver
Meets EIA RS-485 standard 5 Mbps data rate Single 5 V supply
  –7 V to +12 V bus common-mode range High speed, low power BiCMOS Thermal shutdown protection Short-circuit protection Driver propagation delay: 10 ns typical Receiver propagation delay: 15
Manufacture
Analog Devices
ADM7172
Transient Response CMOS LDO
Input voltage range: 2.3 V to 6.5 V Maximum load current: 2 A Low noise: 5 µV rms independent of output voltage at 100 Hz to 100 kHz Fast transient response: 1.5 μs for 1 mA to 1.5 A load step 60 dB PSRR at 100 kHz Low dropout voltage: 172 mV at 2 A
Manufacture
Analog Devices
ADM6320
Supervisory Circuits with Watchdog and Manual Reset
26 reset threshold options 2.5 V to 5 V in 100 mV increments 4 reset timeout options 1 ms, 20 ms, 140 ms, and 1120 ms (minimum) 4 watchdog timeout options 6.3 ms, 102 ms, 1600 ms, and 25.6 sec (typical) Manual reset input Reset output stages Push-pul
Manufacture
Analog Devices
ICS1700A
QuickSaver Charge Controller for Nickel-Cadmium and Nickel-Metal Hydride Batteries

• Multiple charge termination methods include: Voltage slope Maximum temperature Charge timer Four stage charge sequence: Soft start charge Fast charge Topping charge Maintenance charge Reverse-pulse charging available in all charge stages Four progr
Manufacture
ETC
ADM202
CMOS RS-232 Driver/Receiver
120 kB transmission rate Small (0.1 µF) charge pump capacitors Single 5 V power supply Meets TIA/EIA-232-E and V.28 specifications 2 drivers and 2 receivers On-board dc-to-dc converters ±9 V output swing with 5 V supply Low power BiCMOS: 2.5 mA ICC ±
Manufacture
Analog Devices
ADM706P
Voltage Monitoring Microprocessor
Precision supply voltage monitor 2.63 V (ADM706P, ADM706R, ADM708R) 2.93 V (ADM706S, ADM708S) 3.08 V (ADM706T, ADM708T) 100 μA quiescent current 200 ms reset pulse width Debounced manual reset input (MR) Independent watchdog timer 1.6 second timeout
Manufacture
Analog Devices

Total 508 results






logo
Since 2006. D4U Semicon.   |   Contact Us   |   Privacy Policy   |   Site map