SC18IS600 Datasheet | NXP Semiconductors

description The SC18IS600 is designed to serve as an interface between the standard SPI of a host (microcontroller, microprocessor, chip set, etc.) and the serial I2C-bus. This allows the host to municate directly with other I2C-bus devices. The SC18IS600 can operate as an I2C-bus master-transmitter or master-receiver. The SC18IS600 controls all the I2C-bus specific sequences, protocol, arbitration and timing. 2. Features and benefits - SPI slave interface - SPI Mode 3 - Single master I2C-bus controller - Four General Purpose Input/Output (GPIO) pins - Two quasi-bidirectional I/O pins - 5 V tolerant I/O pins - High-speed SPI: Up to 1.2 Mbit/s - High-speed I2C-bus: 400 kbit/s - 96-byte transmit buffer - 96-byte receive buffer - 2.4 V to 3.6 V operation - Power-down mode with WAKEUP pin - Internal oscillator - Active LOW interrupt output - Available in TSSOP16 package NXP Semiconductors SPI to I2C-bus interface 3. Ordering information Table 1. Ordering information Type number Topside marking SC18IS600IPW/S8 18IS600 Package Name Description TSSOP16 plastic thin shrink small outline package; 16 leads; body width 4.4 mm Version SOT403-1 3.1 Ordering options Table 2. Ordering options Type number Orderable part number SC18IS600IPW/S8 SC18IS600IPW/S8HP[1] Package Packing method TSSOP16 REEL 13" Q4/T2 - STANDARD MARK SMD Minimum Temperature order...