TDA8586
Key Features
- Operating voltage from 8 to 18 V
- Low distortion
- Automatic mode selection (SE or BTL) depending on connected ‘rear’ loads
- Can be used as a stereo amplifier in Bridge-Tied Load (BTL) or quad Single-Ended (SE) amplifiers
- Single-ended mode without loudspeaker capacitor
- Soft clipping, to guarantee good clip behaviour with inductive loads
- Mute and standby mode with one-pin operation
- Diagnostic information for Dynamic Distortion Detector (DDD), high temperature (140 °C) mode of operation and short-circuit
- No switch-on/off plops when switching between standby and mute and from mute to on
- Load detection on ‘rear’ channels when switching from standby to mute
