AT69170E
AT69170E is Space FPGA Configuration Memory manufactured by Atmel.
Features
..
- 4Mbits x1 Non Volatile Memory Designed to Store Field Programmable Gate
- -
- -
- -
- -
- -
- -
- -
- Arrays (FPGAs) Configurations In-System Programming (ISP) via Two-Wire Bus Simple Interface to SRAM FPGAs patible with Atmel AT40KEL040 and ATF280E FPGAs Cascadable Read-back to Support Additional Configurations or Higher-density Arrays Low-power Rad Hard non volatile CMOS process Programmable Reset Polarity Low-power Dissipation
- Active read: 18m W max
- Standby mode: 3.6m W max High-reliability
- Endurance: 50,000 Write Cycles (page mode)
- Data Retention: 10 Years 4Mbits On-chip Flash Array
- 512 bytes Page Write No Single Event Latch-up below a LET Threshold of 80Me V/mg/cm2 Tested up to a Total Dose of 60KRads (Si) (according to MIL STD 883 Method 1019) Operating Range:
- Voltage: 3V to 3.6V
- Temperature: -55 to +125° C Quality Grades:
- QML-Q or V
- ESCC Package: 305 Mils FP18 Mass: 10 grams
Space FPGA Configuration Memory AT69170E
1. Description
The AT69170E FPGA configuration memory (configurator) is an electrically erasable and re-programmable Rad Hard memory organized as 4Mx1bit. It is an easy-to-use and cost-effective configuration memory for space Field Programmable Grid Array (FPGA). It is manufactured with ATMEL 0.18µm low power non volatile CMOS Rad Hard process. It is packaged in a 18-pin 305 Mils wide Flat Pack package. AT69170E uses a simple serial-access procedure to configure one or more FPGA devices. A two wire interface (TWI) is available for memory programming. The user can select the polarity of the reset function by programming a dedicated test sequence. These devices also support a write-protection mechanism within its programming mode. The factory blanks devices to all ‘1’ before shipping.
Advanced Information
7752A- AERO- 07/07
2. Block Diagram
..
Figure 2-1.
SER_EN WP1(2) WP2(2)
AT69170E Block Diagram
POWER ON RESET
READY
(2)
(1)
7752A- AERO- 07/07
3. Pin Configuration
..
Package...
