AMC-140 Datasheet | MACOM Technology Solutions

Features n +47 d Bm Typical Midband Third Order Intercept n +28 d Bm Typical Midband 1 d B pression n 5.4 d B Typical Midband Noise Figure Description M/A-’s AM-140 is a coupler feedback amplifier with high intercept and pression points. The use of coupler feedback minimizes noise figure and current in a high intercept amplifier. This amplifier is packaged in a flatpack with flanges. Due to the internal power dissipation the thermal rise should be minimized. The ground plane on the PC board should be configured to remove heat from under the package. AM-140 is ideally suited for use where a high intercept, high reliability amplifier is required. FP-9 C-25 Absolute Maximum Ratings 1 Parameter Absolute Maximum Max. Input Power +15 d Bm Vbias +17.0 V Operating Temperature Storage Temperature -55°C to +85°C -65°C to +125°C 1. Operation of this device above any one of these parameters may cause permanent damange. Pin Configuration Pin # 1 2 3 4 5 Function RF OUT GND GND GND Vbias2 Pin # 6 7 8 9 10 Function RF IN GND GND GND Vbias2 2. Bias may be applied to either a single bias pin, or both bias pins. If bias is applied to both bias pins, it is important that potential ground loops be avoided, and that there is adequate filtering on the bias lines. High Performance Amplifier, 29 d B Gain, 10 - 200 MHz AM-/AMC-140 V 5.00 Electrical Specifications3,4 TA = -55°C to +85°C Case Temperature Parameter Test Conditions Frequency Units Min. Typ. Max. Gain 50 MHz @ +25°C 50 MHz d...