AH3775 Datasheet | Diodes Incorporated

Description The AH3775 is a high-voltage medium-sensitivity Hall Effect latch IC designed for mutation of brushless DC motors, flow meters, linear encoders and position sensors in industrial and consumer home appliances and personal care applications. To support wide range of demanding applications, the design is optimized to operate over the supply range of 3.0V to 28V. With chopper stabilized architecture and an internal bandgap regulator to provide temperature pensated supply for internal circuits, the AH3775 provides a reliable solution over the whole operating range. For robustness and protection, the device has a reverse blocking diode with a Zener clamp on the supply. The output has an overcurrent limit and a Zener clamp. Pin Assignments (Top View) GND 2 3 OUTPUT 1 VDD SC59 and SOT23 The single, open drain output can be switched on with South pole of sufficient strength and switched off with North pole of sufficient strength. When the magnetic flux density (B) perpendicular to the package is larger than the operate point (BOP) the output is switched on (pulled low). The output is held latched until magnetic flux density reverses and bees lower than the release point (BRP). The magnetic operating and release polarity is opposite for SOT23 and SC59 packages. SOT23 and SIP-3 packages will require south pole to the part marking side to operate while SC59 will require south pole to the non-part marking side. (Top View) SIP-3 3. OUTPUT 2. GND 1. VDD Features - Bipolar Latch Operation (South Pole: On, North Pole: off) - 3.0V to 28V Operating Voltage Range - Medium Sensitivity: BOP and BRP of +70G and -70G Typical - Single, Open-Drain Output with Overcurrent Limit - Chopper Stabilized Design Provides: - Superior Temperature Stability - Minimal Switch Point Drift - Enhanced Immunity to Stress - Good RF Noise Immunity - Reverse Blocking Diode and Zener Clamp on Supply - -40C to +125C Operating Temperature - ESD (HBM): 6k V - Industry Standard SC59, SOT23 and...