900,000+ datasheet pdf search and download

Datasheet4U offers most rated semiconductors data sheet pdf






AVAGO

AMMP-6522 Datasheet Preview

AMMP-6522 Datasheet

7 to 20 GHz GaAs MMIC LNA/IRM Receiver

No Preview Available !

AMMP-6522
7 to 20 GHz GaAs MMIC LNA/IRM Receiver
in SMT Package
Data Sheet
Description
Avago’s AMMP-6522 is an easy-to-use broadband inte-
grated receiver in a surface mount package. The MMIC
includes a 3-stage LNA to provide gain amplification
and a gate-pumped image-reject mixer for frequency
translation. The overall receiver performs Single Side
Band down-conversion in the 7 to 20 GHz RF signal
range. The LO and RF are matched to 50 Ω. The IF
output is provided in 2-port format where an external
90-degree hybrid can be utilized for full image rejection.
The LNA requires a 4 V, 75 mA power supply, where the
mixer bias is a simple -1 V, 0.1 mA. The MMIC is fabricated
using PHEMT technology. The surface mount package
allows elimination of “chip & wire” assembly for lower
cost. This MMIC is a cost effective alternative to multi-
chip solution that have higher loss and complex assem-
bly.
Package Diagram
IF1 NC IF2
1 23
RF 8
4 LO
Features
5x5 mm Surface Mount Package
Integrated Low Noise Amplifier
Integrated Image Reject Mixer
50 Ω Input and Output Match
Single Supply Bias Pin
Specifications Vd = 4.0 V (75 mA), Vg = -1.0 V (0.1 mA)
RF frequency: 7 to 20 GHz
IF frequency: DC to 3.5 GHz
Conversion Gain (RF/IF): 13 dB
Input Intercept Point: -4 dBm
Image Suppression: 15 dB
Total Noise Figure: 2.4 dB
Application
Microwave radio systems
Satellite VSAT, DBS Up/Down Link
LMDS & Pt-Pt mmW Long Haul
Broadband Wireless Access (including 802.16 and
802.20 WiMax)
WLL and MMDS loops
Functional Block Diagram
765
Vd NC Vg
12
8
76
3
4
PIN FUNCTION
1 IF1
2 NC
3 IF2
4 LO
5 Vg
6 NC
7 Vd
8 RF
5 TOP VIEW
PACKAGE BASE: GND
Attention: Observe precautions for
handling electrostatic sensitive devices.
ESD Machine Model (Class A) :40V
ESD Human Body Model (Class 1A) :150V
Refer to Avago Technologies Application Note A004R:
Electrostatic Discharge, Damage and Control.
Note: MSL Rating = Level 2A
Free Datasheet http://www.Datasheet4U.com




AVAGO

AMMP-6522 Datasheet Preview

AMMP-6522 Datasheet

7 to 20 GHz GaAs MMIC LNA/IRM Receiver

No Preview Available !

Electrical Specifications
1. Small/Large -signal data measured in a fully de-embedded test fixture form TA = 25°C.
2. Pre-assembly into package performance verified 100% on-wafer per AMMC-6522 published specifications.
3. This final package part performance is verified by a functional test correlated to actual performance at one or more
frequencies.
4. Specifications are derived from measurements in a 50 Ω test environment. Aspects of the amplifier performance
may be improved over a more narrow bandwidth by application of additional conjugate, linearity, or low noise
(Гopt) matching.
5. NF is measure on-wafer. Additional bond wires (-0.2nH) at Input could improve NF at some frequencies.
Table 1. RF Electrical Characteristics
TA=25°C, Vd=4.0V, Vg=-1V, Zo=50 Ω, LO=+15dBm, IF=2GHz [1]
Parameter
RF=8GHz, LO=10GHz
Min Typ Max
RF=18GHz, LO=20GHz
Min Typ Max
Noise Figure into 50 Ω, NF
2.6 3.3
3
Conversion Gain, CG
12 13
12 14
Input Third Order Intercept, IIP3
-8 -6
-5 -0.4
Image Rejection, Sup
15 29
15 30
Note:
1. All tested parameters are guaranteed with the following measurement accuracy:
RF=8GHz: ±0.6dB for Conversion Gain, ±10dB for IRR, ±0.5dB for NF, ±0.8dBm for IIP3
RF=18GHz: ±1.8dB for Conversion Gain, ±1.6dB for IRR, ±0.6dB for NF, ±1.7dBm for IIP3
3.3
Unit
dB
dB
dBm
dB
Comment
Table 2. Recommended Operating Range
1. Ambient operational temperature TA = 25°C unless otherwise noted.
2. Channel-to-backside Thermal Resistance (Tchannel (Tch) = 34°C) as measured using infrared microscopy. Thermal
Resistance at backside temperature (Tb) = 25°C calculated from measured data.
Description
Min.
Typical
Max. Unit
Comments
Drain Supply Current, Id
75 95 mA Vd = 4.0 V
Drain Supply Voltage, Vd
34
5
Gate Supply Voltage, Vg
-1.2 -1.0
-0.8
RF Frequency, RFfreq
7
20
LO Frequency, LOfreq
5
22
IF Frequency, IFfreq [1]
DC
3.5
LO Drive Power, LO
+10 +15
+22
Note:
1. Use IF = DC with caution. Please see “Biasing and Operation” for more details.
V
V
GHz
GHz
GHz
dBm
Ig = 0.1mA
2
Free Datasheet http://www.Datasheet4U.com


Part Number AMMP-6522
Description 7 to 20 GHz GaAs MMIC LNA/IRM Receiver
Maker AVAGO
Total Page 7 Pages
PDF Download

AMMP-6522 Datasheet PDF

View PDF for Mobile








Similar Datasheet

1 AMMP-6522 7 to 20 GHz GaAs MMIC LNA/IRM Receiver
AVAGO





Part Number Start With

0    1    2    3    4    5    6    7    8    9    A    B    C    D    E    F    G    H    I    J    K    L    M    N    O    P    Q    R    S    T    U    V    W    X    Y    Z

Site map

Webmaste! click here

Contact us

Buy Components

Privacy Policy