Datasheet4U Logo Datasheet4U.com

HIP1013 - Low Cost Dual Power Distribution Controller

Datasheet Summary

Description

PIN NO.

Connect to source of associated external N-Channel MOSFET switch to sense output voltage.

Features

  • HOT SWAP Dual Power Distribution Control for +5V and +12V or +5V and +3.3V.
  • Provides Fault Isolation.
  • Charge Pump Allows the Use of N-Channel MOSFETs.
  • Redundant Power On Controls.
  • Power Good and Over Current Latch Indicators.
  • Adjustable Turn-On Ramp.
  • Protection During Turn-On.
  • Pb-free Available.

📥 Download Datasheet

Datasheet preview – HIP1013

Datasheet Details

Part number HIP1013
Manufacturer Renesas
File Size 455.61 KB
Description Low Cost Dual Power Distribution Controller
Datasheet download datasheet HIP1013 Datasheet
Additional preview pages of the HIP1013 datasheet.

📁 Similar Datasheet

  • HIP1030 - 1A High Side Driver with Overload Protection (Intersil Corporation)
  • HIP1031 - Half Amp High Side Driver with Overload Protection (Intersil Corporation)
  • HIP1090 - Protected High Side Power Switch with Transient Suppression (Intersil Corporation)
  • HIP0063 - Hex Low Side MOSFET Driver with Serial or Parallel Interface and Diagnostic Fault Control (Intersil Corporation)
  • HIP2106 - 100V/1A Peak/ Low Cost/ High Frequency Half Bridge Driver (Intersil Corporation)
  • HIP2500 - Half Bridge 500VDC Driver (Harris Corporation)
  • HIP4011 - Three Phase Brushless DC Motor Controller (Intersil Corporation)
  • HIP4081 - 80V/2.5A Peak/ High Frequency Full Bridge FET Driver (Intersil Corporation)
  • HIP5010 - 7V/ 17A SynchroFET Complementary Drive Synchronous Half-Bridge (Intersil Corporation)
  • HIP5011 - 7V/ 17A SynchroFET Complementary Drive Synchronous Half-Bridge (Intersil Corporation)
Other Datasheets by Renesas
  • HIP1011 - PCI Hot Plug Controller
  • HIP1011A - PCI Hot Plug Controller
  • HIP1011B - PCI Hot Plug Controller
  • HIP1011D - Dual Slot PCI Hot Plug Controller
  • HIP1011E - Dual Slot PCI Hot Plug Controller
  • HIP1012A - Dual Power Distribution Controller
  • HIP1015 - Power Distribution Controller
  • HIP1016 - Power Distribution Controller

Full PDF Text Transcription

Click to expand full text
HIP1013 NOT RECOMMENDED FOR NEW DESIGNS NO RECOMMENDED REPLACEMENT c1o-8n8t8a-cItNoTuErRTSeIcLhonricwawl Swu.ipnpteorrstiCl.ceonmte/rtsact Low Cost Dual Power Distribution Controller DATASHEET FN4516 Rev 3.00 August 2004 The HIP1013 is a low cost HOT SWAP dual supply power distribution controller. Two external N-Channel MOSFETs are driven to distribute power while providing load fault isolation. At turn-on, the gate of each external N-Channel MOSFET is charged with a 10A current source. Capacitors on each gate (see the Typical Application Diagram), create a programmable ramp (soft turn-on) to control inrush currents. A built in charge pump supplies the gate drive for the 12V supply N-Channel MOSFET switch. Over current protection is facilitated by two external current sense resistors.
Published: |