Datasheet4U Logo Datasheet4U.com

HIP0063 - Hex Low Side MOSFET Driver with Serial or Parallel Interface and Diagnostic Fault Control

Datasheet Summary

Description

The HIP0063 is a logic controlled, six channel Low Side Power Driver.

As shown in the Block Diagram, the outputs are controlled via the serial data interface or, by user option, each output may be independently controlled from the respective parallel input.

Features

  • Six Channel MOSFET Driver with Gate Drive Control by Serial (SPI) or Parallel Interface and an Option for PWM Logic Switching Control.
  • Drain Monitor Provides Fault Detection and Voltage Clamp for Each Channel.
  • Output Voltage Zener Clamp.
  • 67V Typ.
  • 5V CMOS Logic Level Input Control.
  • VCC Logic Level Power Supply - 5V VCC Logic Power Supply - Turns Off Gate Drive for Low or Loss of VCC.
  • VPWR System Level Power Supply Management -.

📥 Download Datasheet

Datasheet preview – HIP0063

Datasheet Details

Part number HIP0063
Manufacturer Intersil Corporation
File Size 61.01 KB
Description Hex Low Side MOSFET Driver with Serial or Parallel Interface and Diagnostic Fault Control
Datasheet download datasheet HIP0063 Datasheet
Additional preview pages of the HIP0063 datasheet.

📁 Similar Datasheet

  • HIP0060 - 50V Quad Low Side Power Driver (Renesas)
  • HIP0061 - 3-Transistor Common Source ESD Protected Power MOSFET Array (Renesas)
  • HIP0045 - 1A/50V Octal Low Side Power Driver (Renesas)
  • HIP0050 - 0.3A/50V Octal Low Side Power Driver (Renesas)
  • HIP0051 - 0.25A/50V Octal Low Side Power Driver (Renesas)
  • HIP0080 - Quad Inverting Power Driver (Renesas)
  • HIP0081 - Quad Inverting Power Driver (Renesas)
  • HIP0082 - Quad Power Driver (Renesas)
  • HIP0084 - Quad Power Driver (Renesas)
  • HIP1011 - PCI Hot Plug Controller (Renesas)
Other Datasheets by Intersil Corporation
  • HIP1030 - 1A High Side Driver with Overload Protection
  • HIP1031 - Half Amp High Side Driver with Overload Protection
  • HIP1090 - Protected High Side Power Switch with Transient Suppression
  • HIP2106 - 100V/1A Peak/ Low Cost/ High Frequency Half Bridge Driver
  • HIP4011 - Three Phase Brushless DC Motor Controller
  • HIP4081 - 80V/2.5A Peak/ High Frequency Full Bridge FET Driver
  • HIP5010 - 7V/ 17A SynchroFET Complementary Drive Synchronous Half-Bridge
  • HIP5011 - 7V/ 17A SynchroFET Complementary Drive Synchronous Half-Bridge

Full PDF Text Transcription

Click to expand full text
HIP0063 PRELIMINARY October 1995 Hex Low Side MOSFET Driver with Serial or Parallel Interface and Diagnostic Fault Control Description The HIP0063 is a logic controlled, six channel Low Side Power Driver. As shown in the Block Diagram, the outputs are controlled via the serial data interface or, by user option, each output may be independently controlled from the respective parallel input. In addition, PWM logic switching control (HLOS) may be directly applied to channels 0 and 1 in parallel, or channels 4 and 5 in parallel. Output fault conditions may be detected as an output load short to supply when the output is ON or as an open load/ground short when the output is OFF. If an over-current short exists at one output, gate drive goes to a low duty cycle mode.
Published: |