Datasheet4U Logo Datasheet4U.com

HIP1015 - Power Distribution Controller

Datasheet Summary

Description

Connect to the low side of the current sense resistor through the current limiting set resistor.

This pin functions as the current limit programming pin.

Features

  • HOT SWAP Single Power Distribution Control (HIP1015 for 12V, HIP1016 for 5V and Low Side Switch).
  • Undervoltage Monitoring and Notification.
  • Overcurrent Fault Isolation.
  • Programmable Current Regulation Level.
  • Programmable Current Limit Time to Latch-Off.
  • Rail to Rail Common Mode Input Voltage Range (HIP1015).
  • Internal Charge Pump Allows the use of N-channel MOSFET (HIP1015).
  • Undervoltage and Overcurrent Latch Indicators.

📥 Download Datasheet

Datasheet preview – HIP1015

Datasheet Details

Part number HIP1015
Manufacturer Renesas
File Size 577.55 KB
Description Power Distribution Controller
Datasheet download datasheet HIP1015 Datasheet
Additional preview pages of the HIP1015 datasheet.

📁 Similar Datasheet

  • HIP1030 - 1A High Side Driver with Overload Protection (Intersil Corporation)
  • HIP1031 - Half Amp High Side Driver with Overload Protection (Intersil Corporation)
  • HIP1090 - Protected High Side Power Switch with Transient Suppression (Intersil Corporation)
  • HIP0063 - Hex Low Side MOSFET Driver with Serial or Parallel Interface and Diagnostic Fault Control (Intersil Corporation)
  • HIP2106 - 100V/1A Peak/ Low Cost/ High Frequency Half Bridge Driver (Intersil Corporation)
  • HIP2500 - Half Bridge 500VDC Driver (Harris Corporation)
  • HIP4011 - Three Phase Brushless DC Motor Controller (Intersil Corporation)
  • HIP4081 - 80V/2.5A Peak/ High Frequency Full Bridge FET Driver (Intersil Corporation)
  • HIP5010 - 7V/ 17A SynchroFET Complementary Drive Synchronous Half-Bridge (Intersil Corporation)
  • HIP5011 - 7V/ 17A SynchroFET Complementary Drive Synchronous Half-Bridge (Intersil Corporation)
Other Datasheets by Renesas
  • HIP1011 - PCI Hot Plug Controller
  • HIP1011A - PCI Hot Plug Controller
  • HIP1011B - PCI Hot Plug Controller
  • HIP1011D - Dual Slot PCI Hot Plug Controller
  • HIP1011E - Dual Slot PCI Hot Plug Controller
  • HIP1012A - Dual Power Distribution Controller
  • HIP1013 - Low Cost Dual Power Distribution Controller
  • HIP1016 - Power Distribution Controller

Full PDF Text Transcription

Click to expand full text
HIP1015, HIP1016 Power Distribution Controllers The HIP1015 and HIP1016 are hot swap power controllers. The HIP1015 is targeted for a +12V bus whereas the HIP1016 is targeted for +5V applications. Each has an undervoltage (UV) monitoring and reporting with a threshold level ~17% lower than the nominal +12V and +5V. The HIP1015 has an integrated charge pump allowing control of up to a +12V bus using an external N-channel MOSFET. The HIP1016 can also be used to control much higher positive or negative voltages in a low side controller configuration. Both the HIP1015 and HIP1016 feature programmable Overcurrent (OC) detection, current limiting regulation with time delay to latch off and soft start. Ordering Information TEMP.
Published: |